Characterization of the Effects of Ducted Fuel Injection in a Compression Ignition Engine PDF Download

Author: Christopher William Nilsen
Publisher:
ISBN:
Category :
Languages : en
Pages : 0

Get Book Here

Book Description
Ducted fuel injection (DFI) has been proposed as a strategy to enhance the fuel/charge-gas mixing within the combustion chamber of a direct-injection mixing-controlled compression-ignition engine. The concept involves injecting each fuel spray through a small tube within the combustion chamber to facilitate the creation of a leaner mixture in the autoignition zone, relative to a conventional free-spray configuration (i.e., a fuel spray that is not surrounded by a duct). This dissertation investigates the effects of ducted fuel injection on engine-out emissions and efficiency with two-orifice and four-orifice injector tips across a wide range of conditions. A numerical study contributes to the understanding of the fluid flow effects of DFI. The experiments in chapter two use a two-orifice fuel injector to test two duct configurations relative to conventional diesel combustion. The result is that DFI is confirmed to be effective at curtailing engine-out soot emissions. It also breaks the tradeoff between emissions of soot and nitrogen oxides (NO[subscript x]) by simultaneously attenuating soot and NO[subscript x] with increasing dilution. The third chapter expands on the second by comparing ducted fuel injection to conventional diesel combustion over a wide range of operating conditions and at higher loads (up to 8.7 bar gross indicated mean effective pressure) with a four-orifice fuel injector. This chapter is achieved through sweeps of intake-oxygen mole-fraction, injection duration, intake pressure, start of combustion timing, fuel-injection pressure, and intake temperature. Ducted fuel injection is shown to curtail engine-out soot emissions at all tested conditions. Under certain conditions, ducted fuel injection can attenuate engine-out soot by over a factor of 100. In addition to producing significantly lower engine-out soot emissions, ducted fuel injection enables the engine to be operated at low-NO[subscript x] conditions that are not feasible with conventional diesel combustion due to high soot emissions. The fourth chapter explores 1.1 bar IMEP[subscript g] (low load) conditions and 10 bar IMEP[subscript g] (higher-load) conditions with the same four-orifice fuel injector as in chapter three. DFI and CDC are directly compared at each operating point in the study. At the idle condition, the intake dilution was swept to elucidate the soot and NO[subscript x] performance of DFI in this new load range. This expands the range of conditions over which DFI has been shown to attenuate soot formation. It also shows that DFI enables low-NO[subscript x], low-load operation that is not achievable with CDC due to excessive soot formation at high dilution levels. The fifth chapter uses a numerical model to develop the understanding of the fluid flow effects of DFI. This enabled studies of entrainment and mixing that would have been much more challenging to do in an experiment. This showed that DFI enhances charge gas entrainment before the duct and blocks entrainment inside of the duct. Mixing is enhanced by the duct, which resulted in lower peak equivalence ratios at the end of the duct.