Fan Noise Research at NASA

Fan Noise Research at NASA PDF Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 12

Get Book Here

Book Description

Fan Noise Research at NASA

Fan Noise Research at NASA PDF Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 12

Get Book Here

Book Description


Evaluation of the Tone Fan Noise Design/Prediction System (TFaNS) at the NASA Glenn Research Center

Evaluation of the Tone Fan Noise Design/Prediction System (TFaNS) at the NASA Glenn Research Center PDF Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
ISBN: 9781721196593
Category :
Languages : en
Pages : 28

Get Book Here

Book Description
Version 1.4 of TFaNS, the Tone Fan Noise Design/Prediction System. has recently been evaluated at the NASA Glenn Research Center. Data from tests of the Allison Ultra High Bypass Fan (UHBF) were used to compare to predicted farfield directivities for the radial stator configuration. There was good agreement between measured and predicted directivities at low fan speeds when rotor effects were neglected in the TFaNS calculations. At higher fan speeds, TFaNS is shown to be useful in predicting overall trends rather than absolute sound pressure levels. Koch, L. Danielle Glenn Research Center E-12011

Active Control of Fan Noise

Active Control of Fan Noise PDF Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
ISBN: 9781722156800
Category :
Languages : en
Pages : 54

Get Book Here

Book Description
This report describes the Active Noise Cancellation (ANC) System designed by General Electric and tested in the NASA Lewis Research Center's (LERC) 48 inch Active Noise Control Fan (ANCF). The goal of this study is to assess the feasibility of using wall mounted secondary acoustic sources and sensors within the duct of a high bypass turbofan aircraft engine for global active noise cancellation of fan tones. The GE ANC system is based on a modal control approach. A known acoustic mode propagating in the fan duct is canceled using an array of flush-mounted compact sound sources. The canceling modal signal is generated by a modal controller. Inputs to the controller are signals from a shaft encoder and from a microphone array which senses the residual acoustic mode in the duct. The key results are that the (6,0) was completely eliminated at the 920 Hz design frequency and substantially reduced elsewhere. The total tone power was reduced 6.8 dB (out of a possible 9.8 dB). Farfield reductions of 15 dB (SPL) were obtained. The (4,0) and (4,1) modes were reduced simultaneously yielding a 15 dB PWL decrease. The results indicate that global attenuation of PWL at the target frequency was obtained in the aft quadrant using an ANC actuator and sensor system totally contained within the duct. The quality of the results depended on precise mode generation. High spillover into spurious modes generated by the ANC actuator array caused less than optimum levels of PWL reduction. The variation in spillover is believed to be due to calibration procedure, but must be confirmed in subsequent tests. Pla, Frederic G. and Hu, Ziqiang and Sutliff, Daniel L. Glenn Research Center...

NASA Technical Paper

NASA Technical Paper PDF Author:
Publisher:
ISBN:
Category : Astronautics
Languages : en
Pages : 386

Get Book Here

Book Description


Aeroacoustics of Flight Vehicles

Aeroacoustics of Flight Vehicles PDF Author: Harvey H. Hubbard
Publisher:
ISBN:
Category : Aerodynamic noise
Languages : en
Pages : 620

Get Book Here

Book Description


Acoustic Performance of the GEAE UPS Research Fan in the NASA Glenn 9- by 15-Foot Low-Speed Wind Tunnel

Acoustic Performance of the GEAE UPS Research Fan in the NASA Glenn 9- by 15-Foot Low-Speed Wind Tunnel PDF Author: National Aeronaut Administration (Nasa)
Publisher: Independently Published
ISBN:
Category :
Languages : en
Pages : 82

Get Book Here

Book Description
A model advanced turbofan was acoustically tested in the NASA Glenn 9- by 15-Foot Low-Speed Wind Tunnel in 1994. The Universal Propulsion Simulator fan was designed and manufactured by General Electric Aircraft Engines, and included an active core, as well as bypass, flow paths. The fan was tested with several rotors featuring unswept, forward-swept and aft-swept designs of both metal and composite construction. Sideline acoustic data were taken with both hard and acoustically treated walls in the flow passages. The fan was tested within an airflow at a Mach number of 0.20, which is representative of aircraft takeoff/approach conditions. All rotors showed similar aerodynamic performance. However, the composite rotors typically showed higher noise levels than did corresponding metal rotors. Aft and forward rotor sweep showed at most modest reductions of transonic multiple pure tone levels. However, rotor sweep often introduced increased rotor-stator interaction tone levels. Broadband noise was typically higher for the composite rotors and also for the aft-swept metal rotor. Transonic MPT generation was reduced with increasing fan axis angle of attack (AOA); however, higher downstream noise levels did increase with AOA resulting in higher overall Effective Perceived Noise Level. Woodward, Richard P. and Hughes, Christopher E. Glenn Research Center NASA/TM-2012-217450, E-18180 WBS 561581.02.08.03.45.02.04

Active Control of Fan Noise: Feasibiity Study Final Report ... Nasa-cr-198513 ... Mar. 24, 1997

Active Control of Fan Noise: Feasibiity Study Final Report ... Nasa-cr-198513 ... Mar. 24, 1997 PDF Author:
Publisher:
ISBN:
Category :
Languages : en
Pages :

Get Book Here

Book Description


Sources and Levels of Background Noise in the NASA Ames 40- By 80-Foot Wind Tunnel

Sources and Levels of Background Noise in the NASA Ames 40- By 80-Foot Wind Tunnel PDF Author: National Aeronautics and Space Adm Nasa
Publisher: Independently Published
ISBN: 9781729270677
Category : Science
Languages : en
Pages : 46

Get Book Here

Book Description
Background noise levels are measured in the NASA Ames Research Center 40- by 80-Foot Wind Tunnel following installation of a sound-absorbent lining on the test-section walls. Results show that the fan-drive noise dominated the empty test-section background noise at airspeeds below 120 knots. Above 120 knots, the test-section broadband background noise was dominated by wind-induced dipole noise (except at lower harmonics of fan blade-passage tones) most likely generated at the microphone or microphone support strut. Third-octave band and narrow-band spectra are presented for several fan operating conditions and test-section airspeeds. The background noise levels can be reduced by making improvements to the microphone wind screen or support strut. Empirical equations are presented relating variations of fan noise with fan speed or blade-pitch angle. An empirical expression for typical fan noise spectra is also presented. Fan motor electric power consumption is related to the noise generation. Preliminary measurements of sound absorption by the test-section lining indicate that the 152 mm thick lining will adequately absorb test-section model noise at frequencies above 300 Hz. Soderman, Paul T. Ames Research Center RTOP 505-61-11

Fan Rig Noise Spectral Correction for Nasa 9'X 15' Low-Speed Wind Tunnel

Fan Rig Noise Spectral Correction for Nasa 9'X 15' Low-Speed Wind Tunnel PDF Author: Nasa Technical Reports Server (Ntrs)
Publisher: BiblioGov
ISBN: 9781289277666
Category :
Languages : en
Pages : 26

Get Book Here

Book Description
Aircraft engine noise research and development depends on the ability to study and predict the noise created by each engine component in isolation. Fan noise testing, however, requires a significant support system including a drive mechanism to turn the fan, a device to smooth the flow into the fan, and a stand to raise the fan off the ground each of which has the potential to create its own noise. A methodology was therefore developed to improve the data quality for the 9x15 Low Speed Wind Tunnel (LSWT) at the NASA Glenn Research Center that identifies three noise sources: fan noise, jet noise, and rig noise. The jet noise and rig noise was then measured by mounting a scale model of the 9x15 LSWT setup in a jet rig to simulate everything except the rotating machinery that characterizes fan noise. The data showed that the spectra measured in the LSWT has a strong rig noise component at frequencies as high as 3 kHz depending on the fan and speed. The jet noise was determined to be significantly lower than the rig noise. A mathematical model for the rig noise was then developed using a multi-dimensional least squares fit to the rig noise data. This allows the rig noise to be subtracted or removed, depending on the amplitude of the rig noise relative to the fan noise, at any given frequency, observer angle, or nozzle pressure ratio. The impact of isolating the fan noise with this method on spectra, overall power level (OAPWL), and Effective Perceived Noise Level (EPNL) is studied.

Progress on NASA Research Relating to Noise Alleviation of Large Subsonic Jet Aircraft

Progress on NASA Research Relating to Noise Alleviation of Large Subsonic Jet Aircraft PDF Author: United States. National Aeronautics and Space Administration
Publisher:
ISBN:
Category : Airplanes
Languages : en
Pages : 698

Get Book Here

Book Description