Effect of Flow Unsteadiness on Soot Morphology

Effect of Flow Unsteadiness on Soot Morphology PDF Author: Jidong Xiao
Publisher:
ISBN:
Category :
Languages : en
Pages : 152

Get Book Here

Book Description
Keywords: PAH PLIF, soot morphology, LII, Laser scattering.

Effect of Flow Unsteadiness on Soot Morphology

Effect of Flow Unsteadiness on Soot Morphology PDF Author: Jidong Xiao
Publisher:
ISBN:
Category :
Languages : en
Pages : 152

Get Book Here

Book Description
Keywords: PAH PLIF, soot morphology, LII, Laser scattering.

Effect of Flow Unsteadiness on Soot Morphology

Effect of Flow Unsteadiness on Soot Morphology PDF Author:
Publisher:
ISBN:
Category :
Languages : en
Pages :

Get Book Here

Book Description
The morphology of combustion-generated soot is of fundamental interest, but is difficult to measure. A new planar diagnostic technique was developed for morphology measurements in simple laminar flames. Additionally, Polycyclic Aromatic Hydrocarbons, (PAH) the precursors to soot formation, were measured non-intrusively in an unsteady laminar flame to determine the characteristic time scales of their formation. An existing point-wise laser scattering technique to determine soot morphology was extended to a planar technique and applied to a laminar ethylene air co-flow flame. An Nd:YAG laser (532 nm) was used to illuminate the soot particles and the resulting scattered light was collected over a wide range of angles. A low power laser was used to eliminate fluorescence and incandescence interferences. Simultaneous laser induced incandescence measurements were used to determine the soot volume fraction. Six morphological parameters, including primary spherule size and mass fractal dimension, were derived using this new planar measurement technique based on RDG/PFA theory. The results clearly show the soot formation processes, including inception, agglomeration, and oxidization. A two-angle approximate method was also demonstrated and shown to be applicable for instantaneous measurements in unsteady flames. The approximate method can provide limited soot morphology information including primary particle size and number of primary particles per aggregate, when the fractal dimension and distribution are assumed. The approximate method was not suitable over the entire region of this flame because the fractal dimension varies significantly from the assumed value of 1.8, particularly in the soot inception zone. Three different size classes of PAH were measured qualitatively via laser induced fluorescence by detecting fluorescence in different spectral regions. The relative concentrations of these PAH were measured in counterflow diffusion flames subjected to both steady and.

Soot Morphology in Unsteady Counterflow Diffusion

Soot Morphology in Unsteady Counterflow Diffusion PDF Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 0

Get Book Here

Book Description
Due to the resulting reduction of efficiency, providing an IR source for tracking and targeting, and its harmful effects on human health, soot emission from diesel engines continues to be of interest to the US Army. The broad focus of this three-year project has been to better understand the soot formation processes occurring in diesel engines though experimentation in simple unsteady counterflow diffusion flames. Specifically, we have developed a planar diagnostic technique to measure the morphology (fractal dimension, primary spherule diameter, number if spherules per aggregate, etc) of soot in a plane using optical techniques, measured soot volume fraction in high pressure jet diffusion flames (up to 30 atmospheres), and measured a range of PAR (three different size classes) in an unsteady counterflow diffusion flame.

Soot Morphology in Unsteady Counterflow Diffusion Flames

Soot Morphology in Unsteady Counterflow Diffusion Flames PDF Author: William Roberts
Publisher:
ISBN:
Category :
Languages : en
Pages : 4

Get Book Here

Book Description
As Diesel engines consume the majority of the injected fuel in diffusion controlled combustion processes compared to the relatively short initial premixed phase, and diffusion flames have a greater propensity to form soot, particulate matter emission from Diesel engines can considerable. These particles have a much stronger thermal signature compared to gas phase products, water and carbon dioxide, and render Diesel-powered vehicles susceptible to tracking and targeting via IR sensors. This IR signature will decay with time as the particles cool, and this temporal profile is a function of the morphology of the soot. Therefore, it is important to understand, and eventually control, not only the soot volume fraction of the particulate matter, but also its morphology.

Soot Morphology in a Laminar Co-flow Diffusion Flame

Soot Morphology in a Laminar Co-flow Diffusion Flame PDF Author: Jidong Xiao
Publisher:
ISBN:
Category :
Languages : en
Pages :

Get Book Here

Book Description


The Evolution of Soot Morphology in Laminar Co-Flow Diffusion Flames of the Surrogates for Jet A-1 and a Synthetic Kerosene

The Evolution of Soot Morphology in Laminar Co-Flow Diffusion Flames of the Surrogates for Jet A-1 and a Synthetic Kerosene PDF Author: Mohammad Reza Kholghy
Publisher:
ISBN: 9780494919699
Category :
Languages : en
Pages :

Get Book Here

Book Description


The Effects of Unsteady Hydrodynamics on Soot Formation in a Counterflow Diffusion Flame

The Effects of Unsteady Hydrodynamics on Soot Formation in a Counterflow Diffusion Flame PDF Author: Michele Elaine Riggen-DeCroix
Publisher:
ISBN:
Category : Combustion
Languages : en
Pages : 420

Get Book Here

Book Description


Effect of Pressure on Soot Morphology in Laminar Diffusion Flames

Effect of Pressure on Soot Morphology in Laminar Diffusion Flames PDF Author: Ben Gigone
Publisher:
ISBN:
Category :
Languages : en
Pages : 0

Get Book Here

Book Description
The effect of pressure on soot aggregate morphology in laminar diffusion flames, specifically pertaining to primary soot particle size and soot aggregate fractal parameters, was investigated in methane-air and nitrogen-diluted ethylene flames. Soot aggregate samples were collected by thermophoretic sampling within a high-pressure combusting chamber. Soot samples were imaged via transmission electron microscopy followed by an automated imaging detection method. The experiments covered pressures from 7 to 30 bar at vertical flame heights of 3, 6, and 8 mm in methane-air flames, and 3 to 6 bar at heights of 2, 5, 10, and 15 mm in nitrogen-diluted ethylene flames. It was observed that mean primary soot particle size increased with increasing pressure for both fuel types at virtually all flame locations. The fractal dimension was found to vary with pressure for both fuel cases, suggesting that a universal soot aggregate fractal value may not be justified in high-pressure flames.

Army Research Office and Air Force Office of Scientific Research: 2002 Contractors Meeting in Chemical Propulsion

Army Research Office and Air Force Office of Scientific Research: 2002 Contractors Meeting in Chemical Propulsion PDF Author: David M. Mann
Publisher:
ISBN:
Category : Science
Languages : en
Pages : 186

Get Book Here

Book Description
Abstracts are given for 6.1 basic research in chemical propulsion sponsored by the Army Research Office and the Air Force Office of Scientific Research.

Scientific and Technical Aerospace Reports

Scientific and Technical Aerospace Reports PDF Author:
Publisher:
ISBN:
Category : Aeronautics
Languages : en
Pages : 702

Get Book Here

Book Description