Soot Morphology in Unsteady Counterflow Diffusion Flames PDF Download
Are you looking for read ebook online? Search for your book and save it on your Kindle device, PC, phones or tablets. Download Soot Morphology in Unsteady Counterflow Diffusion Flames PDF full book. Access full book title Soot Morphology in Unsteady Counterflow Diffusion Flames by William Roberts. Download full books in PDF and EPUB format.
Author: William Roberts
Publisher:
ISBN:
Category :
Languages : en
Pages : 4
Get Book Here
Book Description
As Diesel engines consume the majority of the injected fuel in diffusion controlled combustion processes compared to the relatively short initial premixed phase, and diffusion flames have a greater propensity to form soot, particulate matter emission from Diesel engines can considerable. These particles have a much stronger thermal signature compared to gas phase products, water and carbon dioxide, and render Diesel-powered vehicles susceptible to tracking and targeting via IR sensors. This IR signature will decay with time as the particles cool, and this temporal profile is a function of the morphology of the soot. Therefore, it is important to understand, and eventually control, not only the soot volume fraction of the particulate matter, but also its morphology.
Author: William Roberts
Publisher:
ISBN:
Category :
Languages : en
Pages : 4
Get Book Here
Book Description
As Diesel engines consume the majority of the injected fuel in diffusion controlled combustion processes compared to the relatively short initial premixed phase, and diffusion flames have a greater propensity to form soot, particulate matter emission from Diesel engines can considerable. These particles have a much stronger thermal signature compared to gas phase products, water and carbon dioxide, and render Diesel-powered vehicles susceptible to tracking and targeting via IR sensors. This IR signature will decay with time as the particles cool, and this temporal profile is a function of the morphology of the soot. Therefore, it is important to understand, and eventually control, not only the soot volume fraction of the particulate matter, but also its morphology.
Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 0
Get Book Here
Book Description
Due to the resulting reduction of efficiency, providing an IR source for tracking and targeting, and its harmful effects on human health, soot emission from diesel engines continues to be of interest to the US Army. The broad focus of this three-year project has been to better understand the soot formation processes occurring in diesel engines though experimentation in simple unsteady counterflow diffusion flames. Specifically, we have developed a planar diagnostic technique to measure the morphology (fractal dimension, primary spherule diameter, number if spherules per aggregate, etc) of soot in a plane using optical techniques, measured soot volume fraction in high pressure jet diffusion flames (up to 30 atmospheres), and measured a range of PAR (three different size classes) in an unsteady counterflow diffusion flame.
Author:
Publisher:
ISBN:
Category :
Languages : en
Pages :
Get Book Here
Book Description
The morphology of combustion-generated soot is of fundamental interest, but is difficult to measure. A new planar diagnostic technique was developed for morphology measurements in simple laminar flames. Additionally, Polycyclic Aromatic Hydrocarbons, (PAH) the precursors to soot formation, were measured non-intrusively in an unsteady laminar flame to determine the characteristic time scales of their formation. An existing point-wise laser scattering technique to determine soot morphology was extended to a planar technique and applied to a laminar ethylene air co-flow flame. An Nd:YAG laser (532 nm) was used to illuminate the soot particles and the resulting scattered light was collected over a wide range of angles. A low power laser was used to eliminate fluorescence and incandescence interferences. Simultaneous laser induced incandescence measurements were used to determine the soot volume fraction. Six morphological parameters, including primary spherule size and mass fractal dimension, were derived using this new planar measurement technique based on RDG/PFA theory. The results clearly show the soot formation processes, including inception, agglomeration, and oxidization. A two-angle approximate method was also demonstrated and shown to be applicable for instantaneous measurements in unsteady flames. The approximate method can provide limited soot morphology information including primary particle size and number of primary particles per aggregate, when the fractal dimension and distribution are assumed. The approximate method was not suitable over the entire region of this flame because the fractal dimension varies significantly from the assumed value of 1.8, particularly in the soot inception zone. Three different size classes of PAH were measured qualitatively via laser induced fluorescence by detecting fluorescence in different spectral regions. The relative concentrations of these PAH were measured in counterflow diffusion flames subjected to both steady and.
Author: Michele Elaine Riggen-DeCroix
Publisher:
ISBN:
Category : Combustion
Languages : en
Pages : 420
Get Book Here
Book Description
Author: Richard L. Axelbaum
Publisher:
ISBN:
Category :
Languages : en
Pages : 510
Get Book Here
Book Description
Author: Jidong Xiao
Publisher:
ISBN:
Category :
Languages : en
Pages :
Get Book Here
Book Description
Author: Keunchul Lee
Publisher:
ISBN:
Category : Combustion
Languages : en
Pages : 400
Get Book Here
Book Description
Author: William Roberts
Publisher:
ISBN:
Category :
Languages : en
Pages : 9
Get Book Here
Book Description
The objective of this research project was to increase the current level of understanding of the interaction between an unsteady hydrodynamic field and the chemical kinetics in a laminar diffusion flamelet. A steady counterflow diffusion flame burner has been modified to allow periodic oscillations of the input velocity. Laser diagnostics were used to quantitatively measure soot volume fraction in an unsteady propane-air counterflow diffusion flame. The instantaneous strain rate at global flame extinction for a propane-air flame has been measured as a function of steady strain and both amplitude and frequency of the unsteady component Two component LDV was used to measure the velocities allowing determination of the true strain rate. The phase lag between velocity and strain rate was quantified. Low frequency oscillations in the reactant flow rates increased net soot production by as much as 6 times over the steady flame. At low initial strain rates, high frequency oscillations reduce the maximum soot volume fraction by as much as 90% of the steady flame soot concentration. At high initial strain rates, soot production was insensitive to high frequency oscillations.
Author: Mark Alexander Mikofski
Publisher:
ISBN:
Category :
Languages : en
Pages : 394
Get Book Here
Book Description
Author: David M. Mann
Publisher:
ISBN:
Category : Science
Languages : en
Pages : 186
Get Book Here
Book Description
Abstracts are given for 6.1 basic research in chemical propulsion sponsored by the Army Research Office and the Air Force Office of Scientific Research.
