Author: Weihuang Wang
Publisher:
ISBN:
Category :
Languages : en
Pages :

Get Book Here

Book Description
This thesis presents a low-power LDPC decoder design based on speculative scheduling of energy necessary to decode dynamically varying data frame in both block-fading channels and general AWGN channels. A model of a memory-efficient low-power high-throughput multi-rate array LDPC decoder as well as its FPGA implementation results is first presented. Then, I propose a decoding scheme that provides the feature of constant-time decoding and thus facilitates real-time applications where guaranteed data rate is required. It pre-analyzes each received data frame to estimate the maximum number of necessary iterations for frame convergence. The results are then used to dynamically adjust decoder frequency and switch between multiple-voltage levels; thereby energy use is minimized. This is in contrast to the conventional fixed-iteration decoding schemes that operate at a fixed voltage level regardless of the quality of data received. Analysis shows that the proposed decoding scheme is widely applicable for both two-phase message-passing (TPMP) decoding algorithm and turbo decoding message passing (TDMP) decoding algorithm in block fading channels, and it is independent of the specific LDPC decoder architecture. A decoder architecture utilizing our recently published multi-rate decoding architecture for general AWGN channels is also presented. The result of this thesis is a decoder design scheme that provides a judicious trade-off between power consumption and coding gain.

Author: Zhiqiang Cui
Publisher:
ISBN:
Category : Decoders (Electronics)
Languages : en
Pages : 218

Get Book Here

Book Description
Low-Density Parity-check (LDPC) codes have attracted considerable attention due to their capacity approaching performance over AWGN channel and highly parallelizable decoding schemes. They have been considered in a variety of industry standards for the next generation communication systems. In general, LDPC codes achieve outstanding performance with large codeword lengths (e.g., N>1000 bits), which lead to a linear increase of the size of memory for storing all the soft messages in LDPC decoding. In the next generation communication systems, the target data rates range from a few hundred Mbit/sec to several Gbit/sec. To achieve those very high decoding throughput, a large amount of computation units are required, which will significantly increase the hardware cost and power consumption of LDPC decoders. LDPC codes are decoded using iterative decoding algorithms. The decoding latency and power consumption are linearly proportional to the number of decoding iterations. A decoding approach with fast convergence speed is highly desired in practice. This thesis considers various VLSI design issues of LDPC decoder and develops efficient approaches for reducing memory requirement, low complexity implementation, and high speed decoding of LDPC codes. We propose a memory efficient partially parallel decoder architecture suited for quasi-cyclic LDPC (QC-LDPC) codes using Min-Sum decoding algorithm. We develop an efficient architecture for general permutation matrix based LDPC codes. We have explored various approaches to linearly increase the decoding throughput with a small amount of hardware overhead. We develop a multi-Gbit/sec LDPC decoder architecture for QC-LDPC codes and prototype an enhanced partially parallel decoder architecture for a Euclidian geometry based LDPC code on FPGA. We propose an early stopping scheme and an extended layered decoding method to reduce the number of decoding iterations for undecodable and decodable sequence received from channel. We also propose a low-complexity optimized 2-bit decoding approach which requires comparable implementation complexity to weighted bit flipping based algorithms but has much better decoding performance and faster convergence speed.

Author: Masoud Ardakani
Publisher: Library and Archives Canada = Bibliothèque et Archives Canada
ISBN: 9780612943100
Category :
Languages : en
Pages : 308

Get Book Here

Book Description
This dissertation presents new methods for the analysis, design and decoding of low-density parity-check (LDPC) codes. We start by studying the simplest class of decoders: the binary message-passing (BMP) decoders. We show that the optimum BMP decoder must satisfy certain symmetry and isotropy conditions, and prove that Gallager's Algorithm B is the optimum BMP algorithm. We use a generalization of extrinsic information transfer (EXIT) charts to formulate a linear program that leads to the design of highly efficient irregular LDPC codes for the BMP decoder. We extend this approach to the design of irregular LDPC codes for the additive white Gaussian noise channel. We introduce a "semi-Gaussian" approximation that very accurately predicts the behaviour of the decoder and permits code design over a wider range of rates and code parameters than in previous approaches. We then study the EXIT chart properties of the highest rate LDPC code which guarantees a certain convergence behaviour. We also introduce and analyze gear-shift decoding in which the decoder is permitted to select the decoding rule from among a predefined set. We show that this flexibility can give rise to significant reductions in decoding complexity. Finally, we show that binary LDPC codes can be combined with quadrature amplitude modulation to achieve near-capacity performance in a multitone system over frequency selective Gaussian channels.

Author: Jaehong Kim
Publisher:
ISBN:
Category : Algorithms
Languages : en
Pages :

Get Book Here

Book Description
The main objective of our research is to design practical low-density parity-check (LDPC) codes which provide a wide range of code rates in a rate-compatible fashion. To this end, we first propose a rate-compatible puncturing algorithm for LDPC codes at short block lengths (up to several thousand symbols). The proposed algorithm is based on the claim that a punctured LDPC code with a smaller level of recoverability has better performance. The proposed algorithm is verified by comparing performance of intentionally punctured LDPC codes (using the proposed algorithm) with randomly punctured LDPC codes. The intentionally punctured LDPC codes show better bit error rate (BER) performances at practically short block lengths. Even though the proposed puncturing algorithm shows excellent performance, several problems are still remained for our research objective. First, how to design an LDPC code of which structure is well suited for the puncturing algorithm. Second, how to provide a wide range of rates since there is a puncturing limitation with the proposed puncturing algorithm. To attack these problems, we propose a new class of LDPC codes, called efficiently-encodable rate-compatible (E2RC) codes, in which the proposed puncturing algorithm concept is imbedded. The E2RC codes have several strong points. First, the codes can be efficiently encoded. We present low-complexity encoder implementation with shift-register circuits. In addition, we show that a simple erasure decoder can also be used for the linear-time encoding of these codes. Thus, we can share a message-passing decoder for both encoding and decoding in transceiver systems that require an encoder/decoder pair. Second, we show that the non-systematic parts of the parity-check matrix are cycle-free, which ensures good code characteristics. Finally, the E2RC codes having a systematic rate-compatible puncturing structure show better puncturing performance than any other LDPC codes in all ranges of code rates.

Author: Luc Claesen
Publisher: Springer
ISBN: 3319252798
Category : Computers
Languages : en
Pages : 255

Get Book Here

Book Description
This book contains extended and revised versions of the best papers presented at the 22nd IFIP WG 10.5/IEEE International Conference on Very Large Scale Integration, VLSI-SoC 2014, held in Playa del Carmen, Mexico, in October 2014. The 12 papers included in the book were carefully reviewed and selected from the 33 full papers presented at the conference. The papers cover a wide range of topics in VLSI technology and advanced research. They address the current trend toward increasing chip integration and technology process advancements bringing about stimulating new challenges both at the physical and system-design levels, as well as in the test of these systems.

Author: Benjamin Smith
Publisher:
ISBN: 9780494273289
Category :
Languages : en
Pages : 156

Get Book Here

Book Description
This thesis presents new methods to design low-density parity-check (LDPC) codes with reduced decoding complexity. An accurate measure of iterative decoding complexity is introduced. In conjunction with extrinsic information transfer (EXIT) chart analysis, an efficient optimization program is developed, for which the complexity measure is the objective function, and its utility is demonstrated by designing LDPC codes with reduced decoding complexity. For long block lengths, codes designed by these methods match the performance of threshold-optimized codes, but reduce the decoding complexity by approximately one-third. The performance of LDPC codes is investigated when the decoder is constrained to perform a sub-optimal decoding algorithm. Due to their practical relevance, the focus is on the design of LDPC codes for quantized min-sum decoders. For such a decoder, codes designed for the sum-product algorithm are sub-optimal, and an alternative design strategy is proposed, resulting in gains of more than 0.5 dB.

Author: Zhengya Zhang
Publisher:
ISBN:
Category :
Languages : en
Pages : 330

Get Book Here

Book Description

Author: Sunitha Kopparthi
Publisher:
ISBN:
Category :
Languages : en
Pages :

Get Book Here

Book Description
Future technologies such as cognitive radio require flexible and reliable hardware architectures that can be easily configured and adapted to varying coding parameters. The objective of this work is to develop a flexible hardware encoder and decoder for low-density parity-check (LDPC) codes. The design methodologies used for the implementation of a LDPC encoder and decoder are flexible in terms of parity-check matrix, code rate and code length. All these designs are implemented on a programmable chip and tested. Encoder implementations of LDPC codes are optimized for area due to their high complexity. Such designs usually have relatively low data rate. Two new encoder designs are developed that achieve much higher data rates of up to 844 Mbps while requiring more area for implementation. Using structured LDPC codes decreases the encoding complexity and provides design flexibility. The architecture for an encoder is presented that adheres to the structured LDPC codes defined in the IEEE 802.16e standard. A single encoder design is also developed that accommodates different code lengths and code rates and does not require re-synthesis of the design in order to change the encoding parameters. The flexible encoder design for structured LDPC codes is also implemented on a custom chip. The maximum coded data rate of the structured encoder is up to 844 Mbps and for a given code rate its value is independent of the code length. An LDPC decoder is designed and its design methodology is generic. It is applicable to both structured and any randomly generated LDPC codes. The coded data rate of the decoder increases with the increase in the code length. The number of decoding iterations used for the decoding process plays an important role in determining the decoder performance and latency. This design validates the estimated codeword after every iteration and stops the decoding process when the correct codeword is estimated which saves power consumption. For a given parity-check matrix and signal-to-noise ratio, a procedure to find an optimum value of the maximum number of decoding iterations is presented that considers the affects of power, delay, and error performance.

Author: Kevin Cushon
Publisher:
ISBN:
Category :
Languages : en
Pages :

Get Book Here

Book Description
"Low-density parity-check (LDPC) codes are a type of error correcting code that are frequently used in high-performance communications systems, due to their ability to approach the theoretical limits of error correction. However, their iterative soft-decision decoding algorithms suffer from high computational complexity, energy consumption, and auxiliary circuit implementation difficulties. It is of particular interest to develop energy-efficient LDPC decoders in order to decrease cost of operation, increase battery life in portable devices, lessen environmental impact, and increase the range of applications for these powerful codes.In this dissertation, we propose four new LDPC decoder designs with the primary goal of improving energy efficiency over previous designs. First, we present a bidirectional interleaver based on transmission gates, which reduces wiring complexity and associated parasitic energy losses. Second, we present an iterative decoder design based on pulse-width modulated min-sum (PWM-MS). We demonstrate that the pulse width message format reduces switching activity, computational complexity, and energy consumption compared to other recent LDPC decoder designs. Third, wepresent decoders based on differential binary (DB) algorithms. We also propose an improved differential binary (IDB) decoding algorithm, which greatly increases throughput and reduces energy consumption compared to recent decoders ofsimilar error correction capability. Finally, we present decoders based on gear-shift algorithms, which use multiple decoding rules to minimize energy consumption. We propose gear-shift pulse-width (GSP) and IDB with GSP (IGSP) algorithms, and demonstrate that they achieve superior energy efficiency without compromising error correction performance." --

Author: Xiaoheng Chen
Publisher:
ISBN: 9781124906669
Category :
Languages : en
Pages :

Get Book Here

Book Description
Since the rediscovery of low-density parity-check (LDPC) codes in the late 1990s, tremendous progress has been made in code construction and design, decoding algorithms, and decoder implementation of these capacity-approaching codes. Recently, LDPC codes are considered for applications such as high-speed satellite and optical communications, the hard disk drives, and high-density flash memory based storage systems, which require that the codes are free of error-floor down to bit error rate (BER) as low as 10−12 to 10−15. FPGAs are usually used to evaluate the error performance of codes, since one can exploit the finite word length and extremely high internal memory bandwidth of an FPGA. Existing FPGA-based LDPC decoders fail to utilize the configurability and read-first mode of embedded memory in the FPGAs, and thus result in limited throughput and codes sizes. Four optimization techniques, i.e., vectorization, folding, message relocation, and circulant permutation matrix (CPM) sharing, are proposed to improve the throughput, scalability, and efficiency of FPGA-based decoders. Also, a semi-automatic CAD tool called QCSYN (Quasi-Cyclic LDPC decoder SYNthesis) is designed to shorten the implementation time of decoders. Using the above techniques, a high-rate (16129,15372) code is shown to have no error-floor down to the BER of 10−14. Also, it is very difficult to construct codes that do not exhibit an error floor down to 10−15 or so. Without detailed knowledge of dominant trapping sets, a backtracking-based reconfigurable decoder is designed to lower the error floor of a family of structurally compatible quasi-cyclic LDPC codes by one to two orders of magnitudes. Hardware reconfigurability is another significant feature of LDPC decoders. A tri-mode decoder for the (4095,3367) Euclidean geometry code is designed to work with three compatible binary message passing decoding algorithms. Note that this code contains 262080 edges (21.3 times of the (2048,1723) 10GBASE-T code) in its Tanner graph and is the largest code ever implemented. Besides, an efficient QC-LDPC Shift Network (QSN) is proposed to reduce the interconnect delay and control logic of circular shift network, a core component in the reconfigurable decoder that supports a family of structurally compatible codes. The interconnect delay and control logic area are reduced by a factor of 2.12 and 8, respectively. Non-binary LDPC codes are effective in combating burst errors. Using the power representation of the elements in the Galois field to organize both intrinsic and extrinsic messages, we present an efficient decoder architecture for non-binary QC-LDPC codes. The proposed decoder is reconfigurable and can be used to decode any code of a given field size. The decoder supports both regular and irregular non-binary QC-LDPC codes. Using a practical metric of throughput per unit area, the proposed implementation outperforms the best implementations published in research literature to date.