Author: Johns Hopkins University. Applied Physics Laboratory, Silver Spring, Md
Publisher:
ISBN:
Category : Aerodynamics, Supersonic
Languages : en
Pages : 516

Get Book Here

Book Description

Author: T.A. Heppenheimer
Publisher: Courier Dover Publications
ISBN: 0486834514
Category : Technology & Engineering
Languages : en
Pages : 355

Get Book Here

Book Description
This volume from The NASA History Series presents an overview of the science of hypersonics, the study of flight at speeds at which the physics of flows is dominated by aerodynamic heating. The survey begins during the years immediately following World War II, with the first steps in hypersonic research: the development of missile nose cones and the X-15; the earliest concepts of hypersonic propulsion; and the origin of the scramjet engine. Next, it addresses the re-entry problem, which came to the forefront during the mid-1950s, showing how work in this area supported the manned space program and contributed to the development of the orbital shuttle. Subsequent chapters explore the fading of scramjet studies and the rise of the National Aerospace Plane (NASP) program of 1985–95, which sought to lay groundwork for single-stage vehicles. The program's ultimate shortcomings — in terms of aerodynamics, propulsion, and materials — are discussed, and the book concludes with a look at hypersonics in the post-NASP era, including the development of the X-33 and X-34 launch vehicles, further uses for scramjets, and advances in fluid mechanics. Clearly, ongoing research in hypersonics has yet to reach its full potential, and readers with an interest in aeronautics and astronautics will find this book a fascinating exploration of the field's history and future.

Author: Joseph R. Chambers
Publisher:
ISBN:
Category : Aeronautics
Languages : en
Pages : 406

Get Book Here

Book Description

Author: Luigi Crocco
Publisher:
ISBN:
Category : Aerodynamics, Supersonic
Languages : en
Pages : 236

Get Book Here

Book Description
The importance assumed in recent times by experimental supersonic wind tunnels, as well as the power required, has brought about the need for a study which would permit a comparison of the types tested and the principal theoretical plans.

Author: S. Kishore Kumar
Publisher: Springer Nature
ISBN: 9811596018
Category : Technology & Engineering
Languages : en
Pages : 529

Get Book Here

Book Description
This book presents selected papers presented in the Symposium on Applied Aerodynamics and Design of Aerospace Vehicles (SAROD 2018), which was jointly organized by Aeronautical Development Agency (the nodal agency for the design and development of combat aircraft in India), Gas-Turbine Research Establishment (responsible for design and development of gas turbine engines for military applications), and CSIR-National Aerospace Laboratories (involved in major aerospace programs in the country such as SARAS program, LCA, Space Launch Vehicles, Missiles and UAVs). It brings together experiences of aerodynamicists in India as well as abroad in Aerospace Vehicle Design, Gas Turbine Engines, Missiles and related areas. It is a useful volume for researchers, professionals and students interested in diversified areas of aerospace engineering.

Author: R.W. Barnwell
Publisher: Springer Science & Business Media
ISBN: 1461228727
Category : Science
Languages : en
Pages : 415

Get Book Here

Book Description
Research on laminar flow and its transition to turbulent flow has been an important part of fluid dynamics research during the last sixty years. Since transition impacts, in some way, every aspect of aircraft performance, this emphasis is not only understandable but should continue well into the future. The delay of transition through the use of a favorable pressure gradient by proper body shaping (natural laminar flow) or the use of a small amount of suction (laminar flow control) was recognized even in the early 1930s and rapidly became the foundation of much of the laminar flow research in the U.S. and abroad. As one would expect, there have been many approaches, both theoretical and experimental, employed to achieve the substantial progress made to date. Boundary layer stability theories have been formu lated and calibrated by a good deal of wind tunnel and flight experiments. New laminar now airfoils and wings have been designed and many have been employed in aircraft designs. While the early research was, of necessity, concerned with the design of subsonic aircraft interest has steadily moved to higher speeds including those appropriate to planetary entry. Clearly, there have been substantial advances in our understanding of transition physics and in the development and application of transition prediction methodolo gies to the design of aircraft.

Author: Liang Yun
Publisher: Springer Science & Business Media
ISBN: 144190042X
Category : Technology & Engineering
Languages : en
Pages : 459

Get Book Here

Book Description
In the last half-century, high-speed water transportation has developed rapidly. Novel high-performance marine vehicles, such as the air cushion vehicle (ACV), surface effect ship (SES), high-speed monohull craft (MHC), catamaran (CAT), hydrofoil craft (HYC), wave-piercing craft (WPC) and small water area twin hull craft (SWATH) have all developed as concepts, achieving varying degrees of commercial and military success. Prototype ACV and SES have achieved speeds of 100 knots in at calm con- tions; however, the normal cruising speed for commercial operations has remained around 35–50 knots. This is partly due to increased drag in an average coastal s- way where such craft operate services and partly due to limitations of the propulsion systems for such craft. Water jets and water propellers face limitations due to c- itation at high speed, for example. SWATH are designed for reduced motions in a seaway, but the hull form is not a low drag form suitable for high-speed operation. So that seems to lead to a problem – maintain water contact and either water propulsion systems run out of power or craft motions and speed loss are a problem in higher seastates. The only way to higher speed would appear to be to disconnect completely from the water surface. You, the reader, might respond with a question about racing hydroplanes, which manage speeds of above 200 kph. Yes, true, but the power-to-weight ratio is extremely high on such racing machines and not economic if translated into a useful commercial vessel.

Author: Patrick Gallais
Publisher: Springer Science & Business Media
ISBN: 3540736476
Category : Technology & Engineering
Languages : en
Pages : 365

Get Book Here

Book Description
Based on a long engineering experience, this book offers a comprehensive and state-of-the-art analysis of aerodynamic and flight mechanic entry topics. This updated edition had new chapters on Re-entry on Mars mission, flight quality, rarefied aerodynamics and re-entry accuracy. In addition, it provides a large set of application exercises and solutions.

Author: Ernst Heinrich Hirschel
Publisher: Springer Science & Business Media
ISBN: 3540265198
Category : Technology & Engineering
Languages : en
Pages : 419

Get Book Here

Book Description
The last two decades have brought two important developments for aeroth- modynamics. One is that airbreathing hypersonic flight became the topic of technology programmes and extended system studies. The other is the emergence and maturing of the discrete numerical methods of aerodyn- ics/aerothermodynamics complementary to the ground-simulation facilities, with the parallel enormous growth of computer power. Airbreathing hypersonic flight vehicles are, in contrast to aeroassisted re-entry vehicles, drag sensitive. They have, further, highly integrated lift and propulsion systems. This means that viscous eflFects, like boundary-layer development, laminar-turbulent transition, to a certain degree also strong interaction phenomena, are much more important for such vehicles than for re-entry vehicles. This holds also for the thermal state of the surface and thermal surface effects, concerning viscous and thermo-chemical phenomena (more important for re-entry vehicles) at and near the wall. The discrete numerical methods of aerodynamics/aerothermodynamics permit now - what was twenty years ago not imaginable - the simulation of high speed flows past real flight vehicle configurations with thermo-chemical and viscous effects, the description of the latter being still handicapped by in sufficient flow-physics models. The benefits of numerical simulation for flight vehicle design are enormous: much improved aerodynamic shape definition and optimization, provision of accurate and reliable aerodynamic data, and highly accurate determination of thermal and mechanical loads. Truly mul- disciplinary design and optimization methods regarding the layout of thermal protection systems, all kinds of aero-servoelasticity problems of the airframe, et cetera, begin now to emerge.

Author: Chenfeng Li
Publisher: Springer Nature
ISBN: 9811384681
Category : Technology & Engineering
Languages : en
Pages : 348

Get Book Here

Book Description
This book consists of selected peer-reviewed papers presented at the NAFEMS India Regional Conference (NIRC 2018). It covers current topics related to advances in computer aided design and manufacturing. The book focuses on the latest developments in engineering modelling and simulation, and its application to various complex engineering systems. Finite element method/finite element analysis, computational fluid dynamics, and additive manufacturing are some of the key topics covered in this book. The book aims to provide a better understanding of contemporary product design and analyses, and hence will be useful for researchers, academicians, and professionals.