Temperature and Neutron Flux Dependence of In-Reactor Creep for Cold-Worked Zr-2.5Nb PDF Download
Are you looking for read ebook online? Search for your book and save it on your Kindle device, PC, phones or tablets. Download Temperature and Neutron Flux Dependence of In-Reactor Creep for Cold-Worked Zr-2.5Nb PDF full book. Access full book title Temperature and Neutron Flux Dependence of In-Reactor Creep for Cold-Worked Zr-2.5Nb by Robert F. DeAbreu. Download full books in PDF and EPUB format.
Author: Robert F. DeAbreu
Publisher:
ISBN:
Category : Nuclear activation analysis
Languages : en
Pages : 27
Get Book Here
Book Description
Over the past 10 years, internally pressurized capsules made from Zr-2.5Nb tubing have been irradiated in the National Research Universal (NRU) reactor at Chalk River Laboratories at temperatures of 280, 320, and 340°C and dose rates between 3 x 1015 n . m-2 . s-1 and 2 x 1017 n . m-2 . s-1 (E > 1 MeV). Periodic gaging has been used to assess the primary and secondary (steady-state) creep behavior. The objective of this detailed and controlled experiment was to determine, for the first time, the creep and microstructure evolution in Zr-2.5Nb tubing over a wide range of irradiation conditions for fast neutron fluxes applicable to a CANDU pressure tube. Similar but "accelerated" creep experiments have been conducted in the Osiris test reactor at fast neutron fluxes of approximately 1.8 x 1018 n . m-2 . s-1 (E > 1 MeV), much greater than the neutron fluxes in the NRU reactor. Although accelerated tests in high-flux reactors such as Osiris provide information on irradiation creep, they do not represent the neutron flux conditions applicable to a power reactor. Tests covering power reactor operating conditions are needed to develop models for in-reactor creep of pressure tubes under the appropriate conditions. The data from the NRU reactor are compared with results from creep capsules with similar starting microstructures but irradiated in the Osiris reactor. The results show that the steady-state diametral and axial creep rates have a complex dependence on stress, temperature, and fast neutron flux. Data from out-reactor creep tests on unirradiated and pre-irradiated creep capsules that show the effect of prior irradiation on creep are also reported. The results are discussed in terms of a combination of creep mechanisms involving dislocation glide and mass transport.
Author: Robert F. DeAbreu
Publisher:
ISBN:
Category : Nuclear activation analysis
Languages : en
Pages : 27
Get Book Here
Book Description
Over the past 10 years, internally pressurized capsules made from Zr-2.5Nb tubing have been irradiated in the National Research Universal (NRU) reactor at Chalk River Laboratories at temperatures of 280, 320, and 340°C and dose rates between 3 x 1015 n . m-2 . s-1 and 2 x 1017 n . m-2 . s-1 (E > 1 MeV). Periodic gaging has been used to assess the primary and secondary (steady-state) creep behavior. The objective of this detailed and controlled experiment was to determine, for the first time, the creep and microstructure evolution in Zr-2.5Nb tubing over a wide range of irradiation conditions for fast neutron fluxes applicable to a CANDU pressure tube. Similar but "accelerated" creep experiments have been conducted in the Osiris test reactor at fast neutron fluxes of approximately 1.8 x 1018 n . m-2 . s-1 (E > 1 MeV), much greater than the neutron fluxes in the NRU reactor. Although accelerated tests in high-flux reactors such as Osiris provide information on irradiation creep, they do not represent the neutron flux conditions applicable to a power reactor. Tests covering power reactor operating conditions are needed to develop models for in-reactor creep of pressure tubes under the appropriate conditions. The data from the NRU reactor are compared with results from creep capsules with similar starting microstructures but irradiated in the Osiris reactor. The results show that the steady-state diametral and axial creep rates have a complex dependence on stress, temperature, and fast neutron flux. Data from out-reactor creep tests on unirradiated and pre-irradiated creep capsules that show the effect of prior irradiation on creep are also reported. The results are discussed in terms of a combination of creep mechanisms involving dislocation glide and mass transport.
Author:
Publisher: ASTM International
ISBN:
Category :
Languages : en
Pages : 308
Get Book Here
Book Description
Author: D. G. Franklin
Publisher: ASTM International
ISBN: 9780803102590
Category : Science
Languages : en
Pages : 322
Get Book Here
Book Description
Author:
Publisher:
ISBN:
Category : Nuclear reactors
Languages : en
Pages : 35
Get Book Here
Book Description
The contribution of irradiation creep to reactor component deformation can be significant, and in many cases it may be the primary source of deformation. The effective accommodation or control of this deformation mode through design, fabrication, or operating procedures or all three requires a knowledge of the functional dependence of irradiation creep on both metallurgical and environmental variables such as cold work, texture, neutron flux, stress, temperature, and time. Moreover, in reconciling these dependences and in anticipating the nature of irradiation creep in parametric regimes beyond those for which experimental and operational data exist, an understanding of the physical processes or mechanisms that give rise to irradiation creep is requisite. Consequently, a full discussion is provided here of irradiation creep in zirconium alloys with particular emphasis on the characteristics of the phenomenon, its observed dependence on material variables and test and operating conditions, and the current theoretical understanding of irradiation creep as it applies to zirconium.
Author: V. Fidleris
Publisher:
ISBN:
Category :
Languages : en
Pages : 0
Get Book Here
Book Description
Author: L. Walters
Publisher:
ISBN:
Category : In-reactor deformation
Languages : en
Pages : 33
Get Book Here
Book Description
Creep experiments have been performed on biaxially stressed 10 mm diameter Zr-2.5Nb capsules. As the pressurized capsules were obtained from micro-pressure tubes, which were fabricated by the same process as CANDU power reactor pressure tubes, they have a similar microstructure to that of the full-size tubes. The experiments were performed in the OSIRIS test reactor at nominal operating temperatures ranging from 553 and 613 K in fast neutron fluxes up to 2 x 1018 n.m-2.s-1 (E > 1 MeV). Diametral and axial strains are reported as functions of fluence for specimens internally pressurized to hoop stresses from 0 to 160 MPa and irradiated to 26.5 dpa. The effects of microstructure, temperature, and cold work on irradiation creep are shown. The analysis of OSIRIS data combined with data from in-service CANDU tubes has revealed some significant observations regarding pressure tube deformation: (i) that irradiation creep anisotropy varies with temperature, (ii) texture appears to have a more significant effect on axial creep than on diametral creep, (iii) diametral strain appears to be strongly dependent on grain size and aspect ratio, and (iv) that whereas cold-work correlates with the axial creep of the capsules, there appears to be no statistically significant dependence of diametral creep on cold-work.
Author: Shuai Wan
Publisher:
ISBN:
Category :
Languages : en
Pages : 238
Get Book Here
Book Description
As an important structural component in CANDU reactor, the pressure tube, made of coldworked Zr-2.5Nb, experiences a neutron flux under high pressure and elevated temperature during the reactor operation. Notches, existing as defects in the pressure tube, are usually the location where stress concentration and crack initiation happens, which seriously degrade the performance of the pressure tube. However, the concentrated stress at the notch area is expected to be relieved by thermal creep, reducing the possibility of crack occurrence. In this study, synchrotron X-ray diffraction experiments were conducted to collect the lattice strains near the notch in both irradiated and unirradiated Zr-2.5Nb samples which had experienced a thermal creep process for different time periods. Strain maps of the notch area were created for each sample. Stress relaxation over the time is discussed for both parallel and perpendicular to the loading direction and also compared between {10 -10} and {0002} orientations. A FE model was set up for the unirradiated materials, which was verified by the experimental results. This work provides an understanding of the stress relaxation near a notch in Zr-2.5Nb and the stress/strain distribution during the thermal creep, which provides valuable information on the assessment of the reactor operation.
Author: J. J. Holmes
Publisher:
ISBN:
Category : Metals
Languages : en
Pages : 10
Get Book Here
Book Description
The creep properties of 20 per cent cold-worked Zircaloy-2 during neutron irradiation have been determined in the temperature range 275 to 465 C and stress range 20,000 to 35,000 psi. In general, the effects of neutron irradiation on creep are small; however, some differences between in-reactor and ex-reactor tests exist. The activation energy for creep during irradiation is around 90,000 cal/mole. In the absence of irradiation, the activation energy is about equal to the self-difiusion value of 60,000 cal/mole. During reactor outages, a small increase in creep rate occurs. The time required to initiate the increase after a shutdown decreases with increasing temperature.
Author: A. R. Causey
Publisher: Chalk River, Ont. : Reactor Materials Research Branch, Chalk River Laboratories
ISBN:
Category : Anisotropy
Languages : en
Pages : 34
Get Book Here
Book Description
This report investigates the anistrophy of irradiation-enhanced creep of cold-worked Zr-2.5Nb at 548-563 K using internally-pressurized capsules and axially loaded helical-springs. The test specimens were machined from small diameter extruded and cold-worked tubing that had crystallographic texture and microstructure similar to that of CANDU power reactor pressure tubes. The biaxial creep capsules and the helical-springs were irradiated for 9,525 and 16,670 hours, respectively, in a fast neutron flux.
Author: C. E. Ells
Publisher:
ISBN:
Category :
Languages : en
Pages : 0
Get Book Here
Book Description
