Non-linear Stability of Quiet Tunnel Hypersonic Laminar Boundary Layer Flow PDF Download
Are you looking for read ebook online? Search for your book and save it on your Kindle device, PC, phones or tablets. Download Non-linear Stability of Quiet Tunnel Hypersonic Laminar Boundary Layer Flow PDF full book. Access full book title Non-linear Stability of Quiet Tunnel Hypersonic Laminar Boundary Layer Flow by Ndaona Chokani. Download full books in PDF and EPUB format.
Author: Ndaona Chokani
Publisher:
ISBN:
Category :
Languages : en
Pages :
Get Book Here
Book Description
Author: Ndaona Chokani
Publisher:
ISBN:
Category :
Languages : en
Pages :
Get Book Here
Book Description
Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
ISBN: 9781722024642
Category :
Languages : en
Pages : 30
Get Book Here
Book Description
A flared-cone model under adiabatic and cooled-wall conditions was placed in a calibrated, low-disturbance Mach 6 flow and the stability of the boundary layer was investigated using a prototype constant-voltage anemometer. The results were compared with linear-stability theory predictions and good agreement was found in the prediction of second-mode frequencies and growth. In addition, the same 'N = 10' criterion used to predict boundary-layer transition in subsonic, transonic, and supersonic flows under low freestream noise conditions was found to be applicable for the hypersonic flow regime as well. Under cooled-wall conditions, a unique set of spectral data was acquired that documents the linear, nonlinear, and breakdown regions associated with the transition of hypersonic flow under low-noise conditions. Blanchard, Alan E. and Selby, Gregory V. and Wilkinson, Stephen P. Langley Research Center NCC1-180...
Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
ISBN: 9781724242556
Category :
Languages : en
Pages : 232
Get Book Here
Book Description
Hypersonic boundary layer measurements over a flared cone were conducted in a Mach 6 quiet wind tunnel at a freestream unit Reynolds number of 2.82 million/ft. This Reynolds number provided laminar-to-transitional flow over the cone model in a low-disturbance environment. Four interchangeable nose-tips, including a sharp-tip, were tested. Point measurements with a single hot-wire using a novel constant voltage anemometer were used to measure the boundary layer disturbances. Surface temperature and schlieren measurements were also conducted to characterize the transitional state of the boundary layer and to identify instability modes. Results suggest that second mode disturbances were the most unstable and scaled with the boundary layer thickness. The second mode integrated growth rates compared well with linear stability theory in the linear stability regime. The second mode is responsible for transition onset despite the existence of a second mode subharmonic. The subharmonic disturbance wavelength also scales with the boundary layer thickness. Furthermore, the existence of higher harmonics of the fundamental suggests that nonlinear disturbances are not associated with 'high' free stream disturbance levels. Nose-tip radii greater than 2.7% of the base radius completely stabilized the second mode. Lachowicz, Jason T. and Chokani, Ndaona Langley Research Center NASA-CR-198272, NAS 1.26:198272 NCC1-183; RTOP-505-59-50-02...
Author: Alan E. Blanchard
Publisher:
ISBN:
Category : Aerodynamics, Hypersonic
Languages : en
Pages : 120
Get Book Here
Book Description
One of the primary reasons for developing quiet tunnels is for the investigation of high-speed boundary-layer stability and transition phenomena without the transition-promoting effects of acoustic radiation from tunnel walls. In this experiment, a flared-cone model under adiabatic- and cooled-wall conditions was placed in a calibrated, "quiet" Mach 6 flow and the stability of the boundary layer was investigated using a prototype constant-voltage anemometer. The results of this experiment were compared with linear-stability theory predictions and good agreement was found in the prediction of second-mode frequencies and growth. In addition, the same "N = 10" criterion used to predict boundary-layer transition in subsonic, transonic, and supersonic flows was found to be applicable for the hypersonic flow regime as well. Under cooled-wall conditions, a unique set of continuous spectra data was acquired that documents the linear, nonlinear, and breakdown regions associated with the transition of hypersonic flow under low-noise conditions
Author: Jason Thomas Lachowicz
Publisher:
ISBN:
Category :
Languages : en
Pages : 232
Get Book Here
Book Description
Author:
Publisher:
ISBN:
Category :
Languages : en
Pages :
Get Book Here
Book Description
A computational evaluation of two stability experiments conducted in the NASA Langley Mach 6 axisymmetric quiet nozzle test chamber facility is conducted. Navier-Stokes analysis of the mean flow and linear stability theory analysis of boundary layer disturbances is performed in the computations. The effects of adverse pressure gradient and wall cooling are examined. Calculated pressure, temperature and boundary layer thickness distributions show very good overall agreement with experimental measurements. Computed mass flux and total temperature profiles show very good quantitative agreement with uncalibrated hot-wire measurements obtained with the hot-wire operated in high and low overheat modes respectively. Comparisons between calibrated hot-wire data and mean flow computations show excellent agreement in the early stages of the transitional flow. However, examination of the wire Reynolds number and mass flux and total temperature eigenfunction profiles suggest that when operated in high overheat mode the sensitivity of the hot-wire to total temperature is significant. Thus, while uncalibrated hot-wire measurements are useful to characterize the overall features of the flow, calibrated hot-wire measurements are necessary for quantitative comparison with stability theory. Computations show that adverse pressure gradient and wall cooling decrease the boundary layer thickness and increase the frequency and amplification rate of the unstable second mode disturbances; these findings are consistent with the experimental observations.
Author: Glen P. Doggett
Publisher:
ISBN:
Category :
Languages : en
Pages : 136
Get Book Here
Book Description
Author: Kenneth Joseph Franko
Publisher:
ISBN:
Category :
Languages : en
Pages :
Get Book Here
Book Description
The design of vehicles which travel at hypersonic speeds is strongly determined by drag characteristics and heat transfer. A portion of this drag and heating is due to the boundary layer where viscosity and thermal conductivity are most important. The level of drag and heating depends on whether the boundary layer is laminar or turbulent with the latter leading to higher levels of drag and heating. In addition, as high speed boundary layers transition from laminar to turbulent flow, an overshoot of the heat transfer beyond that of turbulent flow has been observed in experiments. In low disturbance environments, transition to turbulence follows the path of receptivity, linear growth, nonlinear interaction, and finally breakdown to turbulence. The linear growth of disturbances can be determined by linear stability theory. An analysis of the predicted growth rates and integrated growth of linear disturbances for hypersonic boundary layers including thermal and chemical non-equilibrium is undertaken. The sensitivity to different chemical assumptions, transport models and thermal boundary conditions is investigated. A disturbance energy norm is proposed and its corresponding balance equation is derived. This energy norm is then to determine the effect of different terms of the linear stability equations and to compute transient growth for hypersonic laminar boundary layers. DNS (Direct Numerical Simulation) is used to simulate the nonlinear breakdown to turbulence for a variety of transition scenarios for both zero pressure gradient and adverse pressure gradient high-speed flat plate boundary layers in order to investigate the mechanism for the overshoot of heat transfer in transitional hypersonic boundary layers. The initial disturbances are excited through suction and blowing at the wall and their frequencies are chosen based on linear stability theory. Different transition mechanisms are investigated including a pair of oblique waves and 2D and 3D instabilities at higher frequencies which are unique to high speed boundary layers. Oblique breakdown shows a clear overshoot in heat transfer and skin friction and leads to a fully turbulent boundary layer. The alternative scenarios also lead to transition but further downstream and without large overshoots in heat transfer. A detailed analysis of the transitional and turbulent regions is undertaken.
Author: Melissa L. Manning
Publisher:
ISBN: 9781423527459
Category :
Languages : en
Pages : 118
Get Book Here
Book Description
A computational evaluation of two stability experiments conducted in the NASA Langley Mach 6 axisymmetric quiet nozzle test chamber facility is conducted. Navier- Stokes analysis of the mean flow and linear stability theory analysis of boundary layer disturbances is performed in the computations. The effects of adverse pressure gradient and wall cooling are examined. Calculated pressure, temperature and boundary layer thickness distributions show very good overall agreement with experimental measurements. Computed mass flux and total temperature profiles show very good quantitative agreement with uncalibrated hot- wire measurements obtained with the hot-wire operated in high and low overheat modes respectively. Comparisons between calibrated hot-wire data and mean flow computations show excellent agreement in the early stages of the transitional flow. However, examination of the wire Reynolds number and mass flux and total temperature eigenfunction profiles suggest that when operated in high overheat mode the sensitivity of the hot-wire to total temperature is significant. Thus, while uncalibrated hot-wire measurements are useful to characterize the overall features of the flow, calibrated hot- wire measurements are necessary for quantitative comparison with stability theory. Computations show that adverse pressure gradient and wall cooling decrease the boundary layer thickness and increase the frequency and amplification rate of the unstable second mode disturbances; these findings are consistent with the experimental observations.
Author: National Aeronautics and Space Adm Nasa
Publisher:
ISBN: 9781731266217
Category :
Languages : en
Pages : 134
Get Book Here
Book Description
An experimental investigation of the effects of angle of attack on hypersonic boundary-layer stability on a flared-cone model was conducted in the low-disturbance Mach-6 Nozzle-Test Chamber Facility at NASA Langley Research Center. This unique facility provided a 'quiet' flow test environment which is well suited for stability experiments because the low levels of freestream 'noise' minimize artificial stimulation of flow-disturbance growth. Surface pressure and temperature measurements documented the adverse-pressure gradient and transition-onset location. Hot-wire anemometry diagnostics were applied to identify the instability mechanisms which lead to transition. In addition, the mean flow over the flared-cone geometry was modeled by laminar Navier-Stokes computations. Results show that the boundary layer becomes more stable on the windward ray and less stable on the leeward ray relative to the zero-degree angle-of-attack case. The second-mode instability dominates the transition process at a zero-degree angle of attack, however, on the windward ray at an angle of attack this mode was completely stabilized. The less-dominant first-mode instability was slightly destabilized on the windward ray. Non-linear mechanisms such as saturation and harmonic generation are identified from the flow-disturbance bispectra. Doggett, Glen P. and Chokani, Ndaona Langley Research Center ANGLE OF ATTACK; AERODYNAMIC NOISE; ZERO ANGLE OF ATTACK; BOUNDARY LAYER STABILITY; HYPERSONIC SPEED; NAVIER-STOKES EQUATION; HYPERSONICS; AERODYNAMIC STABILITY; HYPERSONIC BOUNDARY LAYER; WIND TUNNELS; VELOCITY MEASUREMENT; TEST CHAMBERS; LOW NOISE...
