Experimental Investigation of the Performance of a Mach-2. 7 Two-Dimensional Bifurcated Duct Inlet with 30 Percent Internal Contraction

Experimental Investigation of the Performance of a Mach-2. 7 Two-Dimensional Bifurcated Duct Inlet with 30 Percent Internal Contraction PDF Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
ISBN: 9781722219505
Category :
Languages : en
Pages : 46

Get Book Here

Book Description
An experimental study was conducted to determine the performance of a two-dimensional, mixed-compression bifurcated duct inlet system designed for a free-stream Mach number of 2.7. Thirty percent of the supersonic area contraction occurred internally. A movable ramp was used to vary the contraction ratio for off-design operation. Boundary layer bleed regions were located on the cowl, centerbody, and sidewall surfaces. There were also provisions for vortex generators on the cowl and centerbody of the subsonic diffuser. Data were obtained over the Mach number range of 2.0 to 2.8 and at angles of yaw from 0 deg. to the maximum value prior to inlet un-start. The test at Mach 2.8 was to obtain data for an over- speed condition. The Reynolds number varied from 2.5 to 2.3 million/ft for Mach numbers above 2.5. At Mach numbers of 2.5 and lower, the Reynolds number was set at 2.5 million/ft. Bleed patterns, vortex generator patterns, and ramp position were varied, and three inlet configurations were selected for more extensive study. Two of these configurations had self-starting capability. The self-starting configuration that was developed produced 89 percent total pressure recovery at the compressor face station with 6.8 percent total bleed. The compressor face distortion was about 16 percent. Vortex generators were extremely effective in re-distributing flow but were not as effective in reducing distortion. Excellent flow symmetry was achieved between the separated halves of the inlet, and twin-duct instability was not observed. The ramp tip shock was steeper than expected. This caused the cowl lip shock to be reflected from the ramp instead of being cancelled at the shoulder. However, peak recovery at the throat was still obtained with the ramp near the design position. Wasserbauer, J. F. and Meleason, E. T. and Burstadt, P. L. Glenn Research Center RTOP 537-02-23...

Experimental Investigation of the Performance of a Mach-2. 7 Two-Dimensional Bifurcated Duct Inlet with 30 Percent Internal Contraction

Experimental Investigation of the Performance of a Mach-2. 7 Two-Dimensional Bifurcated Duct Inlet with 30 Percent Internal Contraction PDF Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
ISBN: 9781722219505
Category :
Languages : en
Pages : 46

Get Book Here

Book Description
An experimental study was conducted to determine the performance of a two-dimensional, mixed-compression bifurcated duct inlet system designed for a free-stream Mach number of 2.7. Thirty percent of the supersonic area contraction occurred internally. A movable ramp was used to vary the contraction ratio for off-design operation. Boundary layer bleed regions were located on the cowl, centerbody, and sidewall surfaces. There were also provisions for vortex generators on the cowl and centerbody of the subsonic diffuser. Data were obtained over the Mach number range of 2.0 to 2.8 and at angles of yaw from 0 deg. to the maximum value prior to inlet un-start. The test at Mach 2.8 was to obtain data for an over- speed condition. The Reynolds number varied from 2.5 to 2.3 million/ft for Mach numbers above 2.5. At Mach numbers of 2.5 and lower, the Reynolds number was set at 2.5 million/ft. Bleed patterns, vortex generator patterns, and ramp position were varied, and three inlet configurations were selected for more extensive study. Two of these configurations had self-starting capability. The self-starting configuration that was developed produced 89 percent total pressure recovery at the compressor face station with 6.8 percent total bleed. The compressor face distortion was about 16 percent. Vortex generators were extremely effective in re-distributing flow but were not as effective in reducing distortion. Excellent flow symmetry was achieved between the separated halves of the inlet, and twin-duct instability was not observed. The ramp tip shock was steeper than expected. This caused the cowl lip shock to be reflected from the ramp instead of being cancelled at the shoulder. However, peak recovery at the throat was still obtained with the ramp near the design position. Wasserbauer, J. F. and Meleason, E. T. and Burstadt, P. L. Glenn Research Center RTOP 537-02-23...

Experimental Investigation of the Performance of a Mach-2.7 Two-dimensional Bifurcated Duct Inlet with 30 Percent Internal Contraction

Experimental Investigation of the Performance of a Mach-2.7 Two-dimensional Bifurcated Duct Inlet with 30 Percent Internal Contraction PDF Author: Joseph F. Wasserbauer
Publisher:
ISBN:
Category :
Languages : en
Pages : 50

Get Book Here

Book Description
An experimental study was conducted to determine the performance of a two-dimensional, mixed-compression bifurcated duct inlet system designed for a free-stream Mach number of 2.7. Thirty percent of the supersonic area contraction occurred internally. A movable ramp was used to vary the contraction ratio for off-design operation. Boundary layer bleed regions were located on the cowl, centerbody, and sidewall surfaces. There were also provisions for vortex generators on the cowl and centerbody of the subsonic diffuser. Data were obtained over the Mach number range of 2.0 to 2.8 and at angles of yaw from 0 deg. to the maximum value prior to inlet un-start. The test at Mach 2.8 was to obtain data for an over- speed condition. The Reynolds number varied from 2.5 to 2.3 million/ft for Mach numbers above 2.5. At Mach numbers of 2.5 and lower, the Reynolds number was set at 2.5 million/ft. Bleed patterns, vortex generator patterns, and ramp position were varied, and three inlet configurations were selected for more extensive study. Two of these configurations had self-starting capability. The self-starting configuration that was developed produced 89 percent total pressure recovery at the compressor face station with 6.8 percent total bleed. The compressor face distortion was about 16 percent. Vortex generators were extremely effective in re-distributing flow but were not as effective in reducing distortion. Excellent flow symmetry was achieved between the separated halves of the inlet, and twin-duct instability was not observed. The ramp tip shock was steeper than expected. This caused the cowl lip shock to be reflected from the ramp instead of being cancelled at the shoulder. However, peak recovery at the throat was still obtained with the ramp near the design position.

Study of Compressible Flow Through a Rectangular-to-semiannular Transition Duct

Study of Compressible Flow Through a Rectangular-to-semiannular Transition Duct PDF Author:
Publisher:
ISBN:
Category : Aerodynamics, Supersonic
Languages : en
Pages : 66

Get Book Here

Book Description


A Full Navier-Stokes Analysis of Subsonic Diffuser of a Bifurcated 70/30 Supersonic Inlet for High Speed Civil Transport Application

A Full Navier-Stokes Analysis of Subsonic Diffuser of a Bifurcated 70/30 Supersonic Inlet for High Speed Civil Transport Application PDF Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 22

Get Book Here

Book Description


Proceedings of the ASME Process Industries Division, ... : Presented at the ... ASME Mechanical Engineering Congress and Exposition, ...

Proceedings of the ASME Process Industries Division, ... : Presented at the ... ASME Mechanical Engineering Congress and Exposition, ... PDF Author:
Publisher:
ISBN:
Category : Compressors
Languages : en
Pages : 246

Get Book Here

Book Description


Government Reports Announcements & Index

Government Reports Announcements & Index PDF Author:
Publisher:
ISBN:
Category : Science
Languages : en
Pages : 618

Get Book Here

Book Description


Introduction to Aircraft Flight Mechanics

Introduction to Aircraft Flight Mechanics PDF Author: Thomas R. Yechout
Publisher: AIAA
ISBN: 9781600860782
Category : Aerodynamics
Languages : en
Pages : 666

Get Book Here

Book Description
Based on a 15-year successful approach to teaching aircraft flight mechanics at the US Air Force Academy, this text explains the concepts and derivations of equations for aircraft flight mechanics. It covers aircraft performance, static stability, aircraft dynamics stability and feedback control.

From Archangel to Senior Crown

From Archangel to Senior Crown PDF Author: Peter W. Merlin
Publisher: AIAA (American Institute of Aeronautics & Astronautics)
ISBN:
Category : History
Languages : en
Pages : 240

Get Book Here

Book Description
The Lockheed Blackbirds hold a unique place in the development of aeronautics. In their day, the A-12, YF-12, M-21, D-21, and SR-71 variants outperformed all other jet airplanes in terms of altitude and speed. Now retired, they remain the only production aircraft capable of sustained Mach 3 cruise and operational altitudes above 80,000 feet.This is the first book to address the technical aspects of these incredible aircraft. The author describes the design evolution of the Blackbird, from the Archangel to the Senior Crown (the Air Force's SR-71.) He describes in detail the construction and materials challenges faced by Lockheed, as well as the Blackbird's performance characteristics and capabilities.A NASA historian, the author describes NASA's role in using the aircraft as a flying laboratory to collect data on materials, structures, loads, heating, aerodynamics, and performance for high-speed aircraft. The reader will benefit from the technical and programmatic lessons learned.This volume was produced in cooperation with the National Aeronautics and Space Administration.

Facing the Heat Barrier

Facing the Heat Barrier PDF Author: T.A. Heppenheimer
Publisher: Courier Dover Publications
ISBN: 0486834514
Category : Technology & Engineering
Languages : en
Pages : 355

Get Book Here

Book Description
This volume from The NASA History Series presents an overview of the science of hypersonics, the study of flight at speeds at which the physics of flows is dominated by aerodynamic heating. The survey begins during the years immediately following World War II, with the first steps in hypersonic research: the development of missile nose cones and the X-15; the earliest concepts of hypersonic propulsion; and the origin of the scramjet engine. Next, it addresses the re-entry problem, which came to the forefront during the mid-1950s, showing how work in this area supported the manned space program and contributed to the development of the orbital shuttle. Subsequent chapters explore the fading of scramjet studies and the rise of the National Aerospace Plane (NASP) program of 1985–95, which sought to lay groundwork for single-stage vehicles. The program's ultimate shortcomings — in terms of aerodynamics, propulsion, and materials — are discussed, and the book concludes with a look at hypersonics in the post-NASP era, including the development of the X-33 and X-34 launch vehicles, further uses for scramjets, and advances in fluid mechanics. Clearly, ongoing research in hypersonics has yet to reach its full potential, and readers with an interest in aeronautics and astronautics will find this book a fascinating exploration of the field's history and future.

Intake Aerodynamics

Intake Aerodynamics PDF Author: J. Seddon
Publisher: AIAA (American Institute of Aeronautics & Astronautics)
ISBN:
Category : Science
Languages : en
Pages : 440

Get Book Here

Book Description
"Intake Aerodynamics, Second Edition" presents computational advancements and discoveries in intake aerodynamics. A companion volume to "Practical Intake Aerodynamic Design," this important text considers the problem of airflow, both internal and external to air intake, as applied to civil and military aircraft. It covers the aerodynamics of subsonic and supersonic intakes in real flows, maintaining a progression through the transonic range. Also considered is the joint perspective of the airframe designer and the propulsion specialist in practical cases. Readers will gain insight into the fluid mechanics behind the deceleration of air from free stream to engine velocity, and an understanding of air compression and external drag in extensively revised chapters reflecting progress in the field. More than 300 drawings and diagrams help to illustrate the points defined throughout the book. Copublished with Blackwell Science Ltd. Outside the United States and Canada, order from Blackwell Science Ltd., United Kingdom, tel 44 1865 206 206.