Annual Report on Detailed Studies of Soot Formation in Laminar Diffusion Flames for Application to Modeling Studies PDF Download
Are you looking for read ebook online? Search for your book and save it on your Kindle device, PC, phones or tablets. Download Annual Report on Detailed Studies of Soot Formation in Laminar Diffusion Flames for Application to Modeling Studies PDF full book. Access full book title Annual Report on Detailed Studies of Soot Formation in Laminar Diffusion Flames for Application to Modeling Studies by Robert J. Santoro. Download full books in PDF and EPUB format.
Author: Robert J. Santoro
Publisher:
ISBN:
Category : Soot
Languages : en
Pages :
Get Book Here
Book Description
Author: Robert J. Santoro
Publisher:
ISBN:
Category : Soot
Languages : en
Pages :
Get Book Here
Book Description
Author:
Publisher:
ISBN:
Category :
Languages : en
Pages : 104
Get Book Here
Book Description
An investigation of soot formation in laminar diffusion flames showed that soot particle surface growth under laminar diffusion flame conditions ceases because of the depletion of hydrocarbon species and not soot particle reactivity loss due to thermal aging of the particles. This result was obtained through direct species concentration measurements under well-controlled conditions, while the particle reactivity effects were calculated based on premixed flame results along with particle temperature/time information available from earlier laminar diffusion flame studies. Comparisons with a soot formation model which incorporated detailed chemistry effects showed good agreement in terms of predicted and measured species concentration and soot particle field evolution. In addition, a novel technique for measuring soot volume fraction was developed based on laser-induced incandescence and was successfully applied to similar laminar diffusion flame studies. This technique was extended to droplet and turbulent diffusion flame conditions where a two-dimensional imaging approach was employed to measure soot volume fraction. Finally, the complete data set from these studies was assembled in a form suitable for dissemination on computer diskettes throughout the research community for comparison with modeling efforts.
Author:
Publisher:
ISBN:
Category : Aeronautics
Languages : en
Pages : 692
Get Book Here
Book Description
Author: Qingan Zhang
Publisher:
ISBN: 9780494609002
Category :
Languages : en
Pages : 388
Get Book Here
Book Description
The first goal of this thesis is to develop and validate a modeling tool into which fundamental combustion chemistry and aerosol dynamics theory are implemented for investigating soot formation/oxidation in multi-dimensional laminar coflow diffusion flames taking into account soot polydispersity and fractal-like aggregate structure. The second goal is to use the tool to study soot aggregate formation/oxidation in experimentally studied laminar coflow diffusion flames to advance the understanding of soot aggregate formation/oxidation mechanism.The first part of the thesis deals with the large CPU time problem when detailed models are coupled together. Using the domain decomposition method, a high performance parallel flame code is successfully developed. An advanced sectional aerosol dynamics model which can model fractal-like aggregate structure is successfully implemented into the parallel flame code. The performance of the parallel code is demonstrated through its application to the modeling of soot formation/oxidation in a laminar coflow CH4/air diffusion flame. The parallel efficiency reaches as high as 83%.In the third part of the thesis, the effects of oxidation-driven soot aggregate fragmentation on aggregate structure and soot oxidation rate are studied. Three fragmentation models with different fragmentation patterns are developed and implemented into the sectional aerosol dynamics model. The implementation of oxidation-driven aggregate fragmentation significantly improves the prediction of soot aggregate structure in the soot oxidation region.The second part of the thesis numerically explores soot aggregate formation in a laminar coflow C2H4/air diffusion flame using detailed PAH-based combustion chemistry and a PAH-based soot formation/oxidation model. Compared to the measured data, flame temperature, axial velocity, C2 H2 and OH concentrations, soot volume fraction, the average diameter and the number density of primary particles are reasonably well predicted. However, it is very challenging to predict effectively the average degree of particle aggregation. To do so, particle-particle and fluid-particle interactions that may cause non-unitary soot coagulation efficiency need to be considered. The original coagulation model is enhanced in this thesis to accommodate soot coagulation efficiency. Different types of soot coagulation efficiency are numerically investigated. It is found that a simple adjustment of soot coagulation efficiency from 100% to 20% provides good predictions on soot aggregate structure as well as flame properties.
Author: Meghdad Saffaripour
Publisher:
ISBN:
Category :
Languages : en
Pages :
Get Book Here
Book Description
Author: Adhiraj Dasgupta
Publisher:
ISBN:
Category :
Languages : en
Pages :
Get Book Here
Book Description
Detailed numerical modeling of combustion phenomena, soot formation, and radi-ation is an active area of research. In this work a general-purpose, pressure-based,finite volume code for modeling laminar diffusion flames has been incorporatedinto the CFD code OpenFOAM. The code uses a mixture-averaged model for thecalculation of transport coefficients, and can be used to perform detailed modelingof multi-dimensional laminar flames using realistic molecular transport, and withdetailed chemical mechanisms containing hundreds of chemical species and reac-tions. Two soot models have been incorporated into the code: a semi-empiricaltwo-equation model, as well as a detailed Method of Moments with InterpolativeClosure (MOMIC). An emission-only, optically-thin radiation model has also beenincluded in the code to account for the radiative heat loss, and sophisticated radia-tion models with detailed calculations of spectral properties and radiative intensityhave also been included. The flame code showed excellent scalability on massivelydistributed, high-performance computer systems. The code has been validated bymodeling four axisymmetric, co-flowing laminar diffusion flames, and the resultshave been found to be mostly within experimental uncertainty, and comparableto results reported in the literature for the same and similar configurations. Anumber of parametric studies to study the effects of detailed gas-phase chemistry,soot models and radiation have also been performed on these flame configurations.It has been found that the flames considered in this work are all optically thin,and so the simple, emission-only, optically-thin radiation model can be used tomodel these flames with good accuracy and a reasonable computational effort. Inparticular, the detailed radiation models increase the computational cost by twoorders of magnitude, and thus their applicability in a detailed calculation may belimited.It was found that the two-equation soot model used in conjunction with a gas-phase mechanism that adequately describes the combustion of C2 hydrocarbons produces results in close agreement with experimental data for a 1-bar ethylene-airflame, a 10 bar methane-air flame, as well as an ethane-air flame at 10 bar. Thedetailed MOMIC soot model requires the use of a larger, more detailed gas-phasechemical mechanism containing polycyclic aromatic hydrocarbons (PAH) with fourrings, and thus the computational cost associated with the MOMIC soot modelis significantly higher. The detailed model was used to model the flames, andcomputed soot levels were within a factor of two of the experimental values, whichis typically considered good agreement considering the complex physics involved.The last flame studied using both the soot models was a N2 -diluted ethylene-airflame, in which the predicted values of major gas-phase species were seen to be closeto the experimental values, but the soot levels were off by an order of magnitude.Notwithstanding the lack of agreement with measurements for this flame, the flamesolver with the soot models was demonstrated to be a robust, scalable, and generalcode with potential applications to a variety of laminar flames in the non-premixed,partially premixed and premixed regimes.
Author: Robert J. Santoro
Publisher:
ISBN:
Category :
Languages : en
Pages : 67
Get Book Here
Book Description
Studies emphasizing the effects of fuel concentration and operating pressure on the formation of soot particles have been conducted in a series of laminar diffusion flames. These experiments have shown that fuel concentration has a measurable effect on the amount of soot formed in the flame. However, a simple, constant proportionality between the fuel concentration and soot volume fraction has not been found to apply for the range of flow conditions studied. This observation is believed to be a result of flame residence time and diffusion effects which mitigate the consequences of reduced initial fuel concentration. Comparisons with simple laminar diffusion flame models are currently being used to investigate the relationship between initial fuel concentration and local flame concentration fields. Similar studies of soot formation in laminar diffusion flames as a function of operating pressure have also been completed for ethene, ethane and propene fuel species. Keywords: Soot formation, Soot particles, Diffusion flames. (JES).
Author:
Publisher:
ISBN:
Category :
Languages : en
Pages :
Get Book Here
Book Description
PhD.
Author: Robert W. Schefer
Publisher:
ISBN:
Category :
Languages : en
Pages : 48
Get Book Here
Book Description
Fires pose the dominant risk to the safety and security of nuclear weapons, nuclear transport containers, and DOE and DoD facilities. The thermal hazard from these fires primarily results from radiant emission from high-temperature flame soot. Therefore, it is necessary to understand the local transport and chemical phenomena that determine the distributions of soot concentration, optical properties, and temperature in order to develop and validate constitutive models for large-scale, high-fidelity fire simulations. This report summarizes the findings of a Laboratory Directed Research and Development (LDRD) project devoted to obtaining the critical experimental information needed to develop such constitutive models. A combination of laser diagnostics and extractive measurement techniques have been employed in both steady and pulsed laminar diffusion flames of methane, ethylene, and JP-8 surrogate burning in air. For methane and ethylene, both slot and coannular flame geometries were investigated, as well as normal and inverse diffusion flame geometries. For the JP-8 surrogate, coannular normal diffusion flames were investigated. Soot concentrations, polycyclic aromatic hydrocarbon (PAH) laser-induced fluorescence (LIF) signals, hydroxyl radical (OH) LIF, acetylene and water vapor concentrations, soot zone temperatures, and the velocity field were all successfully measured in both steady and unsteady versions of these various flames. In addition, measurements were made of the soot microstructure, soot dimensionless extinction coefficient (&), and the local radiant heat flux. Taken together, these measurements comprise a unique, extensive database for future development and validation of models of soot formation, transport, and radiation.
Author:
Publisher:
ISBN:
Category : Fossil fuels
Languages : en
Pages : 748
Get Book Here
Book Description
