Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
ISBN: 9781723575563
Category :
Languages : en
Pages : 268
Book Description
A detailed investigation to document momentum and thermal development of boundary layers undergoing natural transition on a heated flat plate was performed. Experimental results of both overall and conditionally sampled characteristics of laminar, transitional, and low Reynolds number turbulent boundary layers are presented. Measurements were acquired in a low-speed, closed-loop wind tunnel with a freestream velocity of 100 ft/s and zero pressure gradient over a range of freestream turbulence intensities (TI) from 0.4 to 6 percent. The distributions of skin friction, heat transfer rate and Reynolds shear stress were all consistent with previously published data. Reynolds analogy factors for R(sub theta) is less than 2300 were found to be well predicted by laminar and turbulent correlations which accounted for an unheated starting length. The measured laminar value of Reynolds analogy factor was as much as 53 percent higher than the Pr(sup -2/3). A small dependence of turbulent results on TI was observed. Conditional sampling performed in the transitional boundary layer indicated the existence of a near-wall drop in intermittency, pronounced at certain low intermittencies, which is consistent with the cross-sectional shape of turbulent spots observed by others. Non-turbulent intervals were observed to possess large magnitudes of near-wall unsteadiness and turbulent intervals had peak values as much as 50 percent higher than were measured at fully turbulent stations. Non-turbulent and turbulent profiles in transitional boundary layers cannot be simply treated as Blasius and fully turbulent profiles, respectively. The boundary layer spectra indicate predicted selective amplification of T-S waves for TI is approximately 0.4 percent. However, for TI is approximately 0.8 and 1.1 percent, T-S waves are localized very near the wall and do not play a dominant role in transition process. Sohn, Ki-Hyeon and Reshotko, Eli Unspecified Center NASA-CR-187068, NAS 1.26:187068 NAG3-...
Experimental Study of Boundary Layer Transition with Elevated Freestream Turbulence on a Heated Flat Plate
Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
ISBN: 9781723575563
Category :
Languages : en
Pages : 268
Book Description
A detailed investigation to document momentum and thermal development of boundary layers undergoing natural transition on a heated flat plate was performed. Experimental results of both overall and conditionally sampled characteristics of laminar, transitional, and low Reynolds number turbulent boundary layers are presented. Measurements were acquired in a low-speed, closed-loop wind tunnel with a freestream velocity of 100 ft/s and zero pressure gradient over a range of freestream turbulence intensities (TI) from 0.4 to 6 percent. The distributions of skin friction, heat transfer rate and Reynolds shear stress were all consistent with previously published data. Reynolds analogy factors for R(sub theta) is less than 2300 were found to be well predicted by laminar and turbulent correlations which accounted for an unheated starting length. The measured laminar value of Reynolds analogy factor was as much as 53 percent higher than the Pr(sup -2/3). A small dependence of turbulent results on TI was observed. Conditional sampling performed in the transitional boundary layer indicated the existence of a near-wall drop in intermittency, pronounced at certain low intermittencies, which is consistent with the cross-sectional shape of turbulent spots observed by others. Non-turbulent intervals were observed to possess large magnitudes of near-wall unsteadiness and turbulent intervals had peak values as much as 50 percent higher than were measured at fully turbulent stations. Non-turbulent and turbulent profiles in transitional boundary layers cannot be simply treated as Blasius and fully turbulent profiles, respectively. The boundary layer spectra indicate predicted selective amplification of T-S waves for TI is approximately 0.4 percent. However, for TI is approximately 0.8 and 1.1 percent, T-S waves are localized very near the wall and do not play a dominant role in transition process. Sohn, Ki-Hyeon and Reshotko, Eli Unspecified Center NASA-CR-187068, NAS 1.26:187068 NAG3-...
Publisher: Createspace Independent Publishing Platform
ISBN: 9781723575563
Category :
Languages : en
Pages : 268
Book Description
A detailed investigation to document momentum and thermal development of boundary layers undergoing natural transition on a heated flat plate was performed. Experimental results of both overall and conditionally sampled characteristics of laminar, transitional, and low Reynolds number turbulent boundary layers are presented. Measurements were acquired in a low-speed, closed-loop wind tunnel with a freestream velocity of 100 ft/s and zero pressure gradient over a range of freestream turbulence intensities (TI) from 0.4 to 6 percent. The distributions of skin friction, heat transfer rate and Reynolds shear stress were all consistent with previously published data. Reynolds analogy factors for R(sub theta) is less than 2300 were found to be well predicted by laminar and turbulent correlations which accounted for an unheated starting length. The measured laminar value of Reynolds analogy factor was as much as 53 percent higher than the Pr(sup -2/3). A small dependence of turbulent results on TI was observed. Conditional sampling performed in the transitional boundary layer indicated the existence of a near-wall drop in intermittency, pronounced at certain low intermittencies, which is consistent with the cross-sectional shape of turbulent spots observed by others. Non-turbulent intervals were observed to possess large magnitudes of near-wall unsteadiness and turbulent intervals had peak values as much as 50 percent higher than were measured at fully turbulent stations. Non-turbulent and turbulent profiles in transitional boundary layers cannot be simply treated as Blasius and fully turbulent profiles, respectively. The boundary layer spectra indicate predicted selective amplification of T-S waves for TI is approximately 0.4 percent. However, for TI is approximately 0.8 and 1.1 percent, T-S waves are localized very near the wall and do not play a dominant role in transition process. Sohn, Ki-Hyeon and Reshotko, Eli Unspecified Center NASA-CR-187068, NAS 1.26:187068 NAG3-...
Numerical Simulation of Unsteady Flows and Transition to Turbulence
Author: O. Pironneau
Publisher: Cambridge University Press
ISBN: 9780521416184
Category : Mathematics
Languages : en
Pages : 536
Book Description
The workshop concentrated on the following turbulence test cases: T1 Boundary layer in an S-shaped duct; T2 Periodic array of cylinders in a channel; T3 Transition in a boundary layer under the influence of free-stream turbulence; T4 & T5: Axisymmetric confined jet flows.
Publisher: Cambridge University Press
ISBN: 9780521416184
Category : Mathematics
Languages : en
Pages : 536
Book Description
The workshop concentrated on the following turbulence test cases: T1 Boundary layer in an S-shaped duct; T2 Periodic array of cylinders in a channel; T3 Transition in a boundary layer under the influence of free-stream turbulence; T4 & T5: Axisymmetric confined jet flows.
Scientific and Technical Aerospace Reports
Author:
Publisher:
ISBN:
Category : Aeronautics
Languages : en
Pages : 702
Book Description
Publisher:
ISBN:
Category : Aeronautics
Languages : en
Pages : 702
Book Description
NASA Technical Paper
Author:
Publisher:
ISBN:
Category : Astronautics
Languages : en
Pages : 212
Book Description
Publisher:
ISBN:
Category : Astronautics
Languages : en
Pages : 212
Book Description
Experimental Study of Boundary Layer Behavior in a Simulated Low Pressure Turbine
Author: Rickey J. Shyne
Publisher:
ISBN:
Category : Turbines
Languages : en
Pages : 166
Book Description
Publisher:
ISBN:
Category : Turbines
Languages : en
Pages : 166
Book Description
NASA Technical Paper
Author: United States. National Aeronautics and Space Administration
Publisher:
ISBN:
Category : Aeronautics
Languages : en
Pages : 20
Book Description
Publisher:
ISBN:
Category : Aeronautics
Languages : en
Pages : 20
Book Description
Fluid Mechanics for Engineers
Author: Meinhard T. Schobeiri
Publisher: Springer Science & Business Media
ISBN: 3642115942
Category : Technology & Engineering
Languages : en
Pages : 517
Book Description
The contents of this book covers the material required in the Fluid Mechanics Graduate Core Course (MEEN-621) and in Advanced Fluid Mechanics, a Ph. D-level elective course (MEEN-622), both of which I have been teaching at Texas A&M University for the past two decades. While there are numerous undergraduate fluid mechanics texts on the market for engineering students and instructors to choose from, there are only limited texts that comprehensively address the particular needs of graduate engineering fluid mechanics courses. To complement the lecture materials, the instructors more often recommend several texts, each of which treats special topics of fluid mechanics. This circumstance and the need to have a textbook that covers the materials needed in the above courses gave the impetus to provide the graduate engineering community with a coherent textbook that comprehensively addresses their needs for an advanced fluid mechanics text. Although this text book is primarily aimed at mechanical engineering students, it is equally suitable for aerospace engineering, civil engineering, other engineering disciplines, and especially those practicing professionals who perform CFD-simulation on a routine basis and would like to know more about the underlying physics of the commercial codes they use. Furthermore, it is suitable for self study, provided that the reader has a sufficient knowledge of calculus and differential equations. In the past, because of the lack of advanced computational capability, the subject of fluid mechanics was artificially subdivided into inviscid, viscous (laminar, turbulent), incompressible, compressible, subsonic, supersonic and hypersonic flows.
Publisher: Springer Science & Business Media
ISBN: 3642115942
Category : Technology & Engineering
Languages : en
Pages : 517
Book Description
The contents of this book covers the material required in the Fluid Mechanics Graduate Core Course (MEEN-621) and in Advanced Fluid Mechanics, a Ph. D-level elective course (MEEN-622), both of which I have been teaching at Texas A&M University for the past two decades. While there are numerous undergraduate fluid mechanics texts on the market for engineering students and instructors to choose from, there are only limited texts that comprehensively address the particular needs of graduate engineering fluid mechanics courses. To complement the lecture materials, the instructors more often recommend several texts, each of which treats special topics of fluid mechanics. This circumstance and the need to have a textbook that covers the materials needed in the above courses gave the impetus to provide the graduate engineering community with a coherent textbook that comprehensively addresses their needs for an advanced fluid mechanics text. Although this text book is primarily aimed at mechanical engineering students, it is equally suitable for aerospace engineering, civil engineering, other engineering disciplines, and especially those practicing professionals who perform CFD-simulation on a routine basis and would like to know more about the underlying physics of the commercial codes they use. Furthermore, it is suitable for self study, provided that the reader has a sufficient knowledge of calculus and differential equations. In the past, because of the lack of advanced computational capability, the subject of fluid mechanics was artificially subdivided into inviscid, viscous (laminar, turbulent), incompressible, compressible, subsonic, supersonic and hypersonic flows.
Modeling of the Heat Transfer in Bypass Transitional Boundary-layer Flows
Author: Frederick F. Simon
Publisher:
ISBN:
Category : Boundary layer
Languages : en
Pages : 20
Book Description
Publisher:
ISBN:
Category : Boundary layer
Languages : en
Pages : 20
Book Description
Engineering Turbulence Modelling and Experiments - 2
Author: F. Martelli
Publisher: Elsevier
ISBN: 1483298558
Category : Technology & Engineering
Languages : en
Pages : 1012
Book Description
Today understanding turbulence is one of the key issues in tackling flow problems in engineering. Powerful computers and numerical methods are now available for solving flow equations, but the simulation of turbulence effects, which are nearly always important in practice, are still at an early stage of development. Successful simulation of turbulence requires the understanding of the complex physical phenomena involved and suitable models for describing the turbulence momentum, heat and mass transfer. The 89 papers, including 5 invited papers, in this volume present and discuss new developments in the area of turbulence modelling and measurements, with particular emphasis on engineering-related problems. The high standard of the contributions on the developing and testing of turbulent models attests to the world-wide interest this domain is currently attracting from researchers.
Publisher: Elsevier
ISBN: 1483298558
Category : Technology & Engineering
Languages : en
Pages : 1012
Book Description
Today understanding turbulence is one of the key issues in tackling flow problems in engineering. Powerful computers and numerical methods are now available for solving flow equations, but the simulation of turbulence effects, which are nearly always important in practice, are still at an early stage of development. Successful simulation of turbulence requires the understanding of the complex physical phenomena involved and suitable models for describing the turbulence momentum, heat and mass transfer. The 89 papers, including 5 invited papers, in this volume present and discuss new developments in the area of turbulence modelling and measurements, with particular emphasis on engineering-related problems. The high standard of the contributions on the developing and testing of turbulent models attests to the world-wide interest this domain is currently attracting from researchers.
Monthly Catalog of United States Government Publications
Author:
Publisher:
ISBN:
Category : Government publications
Languages : en
Pages : 1168
Book Description
Publisher:
ISBN:
Category : Government publications
Languages : en
Pages : 1168
Book Description