Author: Ralph P. Bielat
Publisher:
ISBN:
Category : Aerodynamics, Transonic
Languages : en
Pages : 44
Book Description
Four wing-body combinations of the same plan form (47 degree sweep, 3.5 aspect ratio, and 0.2 taper ratio) were compared at transonic speeds in the Langley 8-foot high-speed tunnel. Three wings were 4, 6, and 9 percent thick; the fourth was 6 percent thick but, on the inner 0.4 span, tapered to 12-percent thickness at the roots.
An Investigation at Transonic Speeds of the Effects of Thickness Ratio and of Thickened Root Sections on the Aerodynamic Characteristics of Wings with 47© Sweepback, Aspect Ratio 3.5, and Taper Ratio 0.2 in the Slotted Test Section of the Langley 8-foot High-speed Tunnel
An Investigation at Transonic Speeds of the Effects of Thickness Ratio and of Thickened Root Sections on the Aerodynamic Characteristics of Wings with 47° Sweepback, Aspect Ratio 3.5, and Taper Ratio 0.2 in the Slotted Test Section of the Langley 8-foot High-speed Tunnel
Author: Ralph P. Bielat
Publisher:
ISBN:
Category : Aerodynamics, Transonic
Languages : en
Pages : 38
Book Description
Publisher:
ISBN:
Category : Aerodynamics, Transonic
Languages : en
Pages : 38
Book Description
Wind Tunnel Wall Correction
Author: B. F. R. Ewald
Publisher:
ISBN:
Category : Aerodynamics
Languages : en
Pages : 578
Book Description
This report was compiled by an international team of wind tunnel wall correction experts. It presents the present state of the art in wind tunnel wall corrections with a special emphasis given to the description of modern wall correction methods based on Computational Fluid Dynamics. This AGARDograph was planned by the AGARD Fluid Dynamics Panel to be a modern sequel of the successful AGARDograph 109 "Subsonic Wind Tunnel Wall Corrections", which was published in 1966. AGARDogaph 109 is still valid and continues to be used to provide wall corrections in many wind tunnels. Nevertheless, in the thirty two years since the publication of AGARDograph 109, much work has been done on the subject, and the influence of the new tool of numerical fluid dynamics was so strong, that a sequel to AGARDograph 109 was considered to be necessary.
Publisher:
ISBN:
Category : Aerodynamics
Languages : en
Pages : 578
Book Description
This report was compiled by an international team of wind tunnel wall correction experts. It presents the present state of the art in wind tunnel wall corrections with a special emphasis given to the description of modern wall correction methods based on Computational Fluid Dynamics. This AGARDograph was planned by the AGARD Fluid Dynamics Panel to be a modern sequel of the successful AGARDograph 109 "Subsonic Wind Tunnel Wall Corrections", which was published in 1966. AGARDogaph 109 is still valid and continues to be used to provide wall corrections in many wind tunnels. Nevertheless, in the thirty two years since the publication of AGARDograph 109, much work has been done on the subject, and the influence of the new tool of numerical fluid dynamics was so strong, that a sequel to AGARDograph 109 was considered to be necessary.
Scientific and Technical Aerospace Reports
Author:
Publisher:
ISBN:
Category : Aeronautics
Languages : en
Pages : 456
Book Description
Lists citations with abstracts for aerospace related reports obtained from world wide sources and announces documents that have recently been entered into the NASA Scientific and Technical Information Database.
Publisher:
ISBN:
Category : Aeronautics
Languages : en
Pages : 456
Book Description
Lists citations with abstracts for aerospace related reports obtained from world wide sources and announces documents that have recently been entered into the NASA Scientific and Technical Information Database.
Investigation at Transonic Speeds of the Loading Over a 45 Degree Sweptback Wing Having an Aspect Ratio of 3, a Taper Ratio of 0.2, and NACA 65A004 Airfoil Sections
Author: Jack F. Runckel
Publisher:
ISBN:
Category : Aerodynamic load
Languages : en
Pages : 104
Book Description
An investigation at transonic speeds of the loading over a 45 degree sweptback wing having an aspect ratio of 3, a taper ratio of 0.2, and NACA 65A004 airfoil sections has been conducted in the Langley16-foot transonic tunnel. Pressure measurements on the wing-body combination were obtained at angles of attack from 0 to 26 degrees at Mach numbers from 0.80 to 0.98 and from 0 to about 12 degrees at Mach numbers from 1.00 to 1.05. Reynolds number, based on the wing mean aerodynamic chord, varied from 7,000,000 to 8,500,000 over the test Mach number range.
Publisher:
ISBN:
Category : Aerodynamic load
Languages : en
Pages : 104
Book Description
An investigation at transonic speeds of the loading over a 45 degree sweptback wing having an aspect ratio of 3, a taper ratio of 0.2, and NACA 65A004 airfoil sections has been conducted in the Langley16-foot transonic tunnel. Pressure measurements on the wing-body combination were obtained at angles of attack from 0 to 26 degrees at Mach numbers from 0.80 to 0.98 and from 0 to about 12 degrees at Mach numbers from 1.00 to 1.05. Reynolds number, based on the wing mean aerodynamic chord, varied from 7,000,000 to 8,500,000 over the test Mach number range.
Transonic Aerodynamic Loading Characteristics of a Wing-body-tail Combination Having 52.5° Sweptback Wing of Aspect Ratio 3 with Conical Wing Camber and Body Indentation for a Design Mach Number [square Root Of] 2
Author: Marlowe D. Cassetti
Publisher:
ISBN:
Category : Transonic wind tunnels
Languages : en
Pages : 104
Book Description
An investigation has been made of the effects of conical wing camber and body indentation according to the supersonic area rule on the aerodynamic wing loading characteristics of a wing-body-tail configuration at transonic speeds. The wing aspect ratio was 3, taper ratio was 0.1, and quarter-chord-line sweepback was 52.5° with 3-percent-thick airfoil sections. The tests were conducted in the Langley 16-foot transonic tunnel at Mach numbers from 0.80 to 1.05 and at angles of attack from 0° to 14°, with Reynolds numbers based on mean aerodynamic chord varying from 7 x 106 to 8 x 106. Conical camber delayed wing-tip stall and reduced the severity of the accompanying longitudinal instability but did not appreciably affect the spanwise load distribution at angles of attack below tip stall. Body indentation reduced to transonic chordwise center-of-pressure travel from about 8 percent to 5 percent of the mean aerodynamic chord.
Publisher:
ISBN:
Category : Transonic wind tunnels
Languages : en
Pages : 104
Book Description
An investigation has been made of the effects of conical wing camber and body indentation according to the supersonic area rule on the aerodynamic wing loading characteristics of a wing-body-tail configuration at transonic speeds. The wing aspect ratio was 3, taper ratio was 0.1, and quarter-chord-line sweepback was 52.5° with 3-percent-thick airfoil sections. The tests were conducted in the Langley 16-foot transonic tunnel at Mach numbers from 0.80 to 1.05 and at angles of attack from 0° to 14°, with Reynolds numbers based on mean aerodynamic chord varying from 7 x 106 to 8 x 106. Conical camber delayed wing-tip stall and reduced the severity of the accompanying longitudinal instability but did not appreciably affect the spanwise load distribution at angles of attack below tip stall. Body indentation reduced to transonic chordwise center-of-pressure travel from about 8 percent to 5 percent of the mean aerodynamic chord.
Transonic Wind-tunnel Investigation of the Effects of Sweepback and Thickness Ratio on the Wing Loads of a Wing-body Combination of Aspect Ratio 4 and Taper Ratio 0.6
Author: Robert J. Platt
Publisher:
ISBN:
Category : Aerodynamic load
Languages : en
Pages : 50
Book Description
A transonic investigation of the effects of sweepback and thickness ratio on the wing loads of a wing in the presence of a body has been made in the Langley 8-foot transonic pressure tunnel. The tests covered wings with a thickness ratio of 6 percent for sweepback angles of 0, 25, and 45 degrees and a thickness ratio of 4 percent for an unswept wing.
Publisher:
ISBN:
Category : Aerodynamic load
Languages : en
Pages : 50
Book Description
A transonic investigation of the effects of sweepback and thickness ratio on the wing loads of a wing in the presence of a body has been made in the Langley 8-foot transonic pressure tunnel. The tests covered wings with a thickness ratio of 6 percent for sweepback angles of 0, 25, and 45 degrees and a thickness ratio of 4 percent for an unswept wing.
Transonic Wind Tunnel Testing
Author: B. H. Goethert
Publisher:
ISBN:
Category : Science
Languages : en
Pages : 420
Book Description
Numerous aspects of transonic aerodynamics include wall interference corrections in conventional wind tunnels, subsonic flow in a variety of wind tunnels, and test results from transonic wind tunnels. 1961 edition.
Publisher:
ISBN:
Category : Science
Languages : en
Pages : 420
Book Description
Numerous aspects of transonic aerodynamics include wall interference corrections in conventional wind tunnels, subsonic flow in a variety of wind tunnels, and test results from transonic wind tunnels. 1961 edition.
Investigation at Transonic Speeds of the Loading Over a 45 Degree Sweptback Wing Having an Aspect Ratio of 3, a Taper Ratio of 0.2, and Naca 65a004 Airfoil Sections
Author: JACK F. RUNCKEL
Publisher:
ISBN:
Category :
Languages : en
Pages : 1
Book Description
An investigation at transonic speeds of the loading over a 45 degree sweptback wing having an aspect ratio of 3, a taper ratio of 0.2, and NACA 65A004 airfoil sections was conducted in the Langley 16-foot transonic tunnel. Pressure measurements on the wing-body combi ation were obtained at angles of attack from 0 degrees to 26 degrees at Mach numbers from 0.80 to 0.98 and at angles of attack from 0 degrees to about 12 degrees at Mach numbers from 1.00 to 1.05. Reynolds number, based on the wing mean aerodynamic c ord varied from 7 times 10 to the 6th po er to 8.5 times 10 to the 6th power over the test Mach number range. Results of the investigation indicate that a highly swept shock originates at the juncture of the wing leading edge and the body at moderate angles of attack and has a large influence on the loading over the inboard wing sections. (Author).
Publisher:
ISBN:
Category :
Languages : en
Pages : 1
Book Description
An investigation at transonic speeds of the loading over a 45 degree sweptback wing having an aspect ratio of 3, a taper ratio of 0.2, and NACA 65A004 airfoil sections was conducted in the Langley 16-foot transonic tunnel. Pressure measurements on the wing-body combi ation were obtained at angles of attack from 0 degrees to 26 degrees at Mach numbers from 0.80 to 0.98 and at angles of attack from 0 degrees to about 12 degrees at Mach numbers from 1.00 to 1.05. Reynolds number, based on the wing mean aerodynamic c ord varied from 7 times 10 to the 6th po er to 8.5 times 10 to the 6th power over the test Mach number range. Results of the investigation indicate that a highly swept shock originates at the juncture of the wing leading edge and the body at moderate angles of attack and has a large influence on the loading over the inboard wing sections. (Author).
Hypersonic Experimental and Computational Capability, Improvement and Validation
Author:
Publisher:
ISBN: 9789283610373
Category : Aerodynamics, Hypersonic
Languages : en
Pages :
Book Description
Publisher:
ISBN: 9789283610373
Category : Aerodynamics, Hypersonic
Languages : en
Pages :
Book Description